99 R/T 10
Enthusiast
Here's a few pics of the install that Mark at Woodhouse did for me!
That is one nice looking engine compartment, only thing missing is a polished intake
Woodhouse Does It
- Thread starter Gary Weeks
- Start date
That is one nice looking engine compartment, only thing missing is a polished intake
Gary Weeks
Viper Owner
That is one nice looking engine compartment, only thing missing is a polished intake
I agree.....I just need someone to polish it for me?
RobZilla
Enthusiast
How many pounds are you putting through the paxton and what were some final numbers???? I need numbers (in addition to the pics)!
Gary Weeks
Viper Owner
How many pounds are you putting through the paxton and what were some final numbers???? I need numbers (in addition to the pics)!
I don't have a boost gauge on it but it's around 6 or 7 psi. The RWHP was 658 and the rwtq was about 620 on a Mustang dyno. So that makes it about 725 HP at the flywheel. Mark set it up on the safe side. It is stock other than the Paxton and motor mounts. It runs really good!
RobZilla
Enthusiast
Most impressive. Those are good numbers. Time to start adding to those with some supplemental mods.
Gary Weeks
Viper Owner
Most impressive. Those are good numbers. Time to start adding to those with some supplemental mods.
I had Mark do my 08 with headers, 3.55's, mounts and PCM also....so I'm good for a bit!
