The anti rotation nub fits properly into the
Block ( both the factory one and the new one ). In fact - I have included a diagram which illustrates that the tensioner actually sits too close to the block relative to the other pulleys.
The vehicle is stock.
All the other pulleys (including the crank)
are in perfect alignment with each other.
It’s the tensioner that doesn’t align.
I even purchased a new one and installed it but it’s exactly the same- out about 1/4 inch.
I’d expect that all the blocks are cast the same ? and...
04 SRT 10- noticed frayed belt - installed new one ( 7 rib belt ) - in 2 days the outboard 2 ribs blew off. Noticed the tensioner was out of alignment- put on new one- same problem. Put old belt and tensioner back on.
Car works fine on 5 rib belt. The 5 belt ribs sit on the inboard 5 ribs of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.