It won't let me reply until you delete some old messages. I've been trying, but get the same error message.
"BlackOutBoxing has exceeded their stored private messages quota and cannot accept further messages until they clear some space."
Clint
This is the message i'm getting when I try to reply to your PM
"BlackOutBoxing has exceeded their stored private messages quota and cannot accept further messages until they clear some space."
Re: Gen 3 III CLUTCH SUGGESTIONS PLEASE! My GIFT for helping - coolest V commercial e
Hand pump clutch bleeder. My 2004 is doing the same thing now, and tomorrow I'm having the clutch and slave replaced. Tonight I removed the rubber bag thing out of the reservoir, Put an O-ring around the...
Re: Gen 3 III CLUTCH SUGGESTIONS PLEASE! My GIFT for helping - coolest V commercial e
Yes your slave is the problem but with 4-6 oz of brake fluid dripping or flying around the bell housing there's more than a good chance that some has gotten on the clutch plate, plus 20k on a viper (unless you...
Re: Gen 3 III CLUTCH SUGGESTIONS PLEASE! My GIFT for helping - coolest V commercial e
I've had a couple done over the years and it's not that expensive of a repair to do at all. Book time to replace the clutch is about 2.7hrs on a Gen3. Every Viper I've put a clutch in got a LUK kit in them...
The dust shield on the back side is barely touching the rotor. You don't need to remove the wheels to check, roll under and and pull it away.
or the ebrake pad, pull up the ebrake a few clicks while coming to a stop to see if it go's away. Not the caliper as the noise would go away once you...
You say it does it with clutch in or out but how about stopped and reeving it up? Clutch pedal in while driving you say does it but the idle will drop below 2000, does the vibration stop once idle drops below 2000?
I think you problem is drive shaft related also, rotate it and try it again...
I've installed Luk clutches in both my 1997 GTS and 2004 Vipers, great holding and pedal has a "stock/OE" feel. Also, you should replace your Slave Cylinder and Resurface the Flywheel.
Clint
I did call Jon B at Parts Rack and nothing available now. He's wanting me to look at the 2014 wheels, Rattler, Sidewinder & Venom. He says they are on sale now, all four wheels for $2380.....doesn't sound bad. Now I'm looking for photos of Gen 3's (conv) with new style wheels to see what they...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.