Recent content by Cyruss

  1. C

    255kb maximum for attached file ?

    Hi, I would like to know if there is a way to upgrade the capacity of the "file attachement". I have only 255kb, and it's not a lot as I have to delete picture from older post to upload new one. A few Mb will be helpfull. thanks a lot.
  2. C

    AEM tune - air temp - ignition & fuel trim

    Hi all. I'm using a AEM v1 stand alone on my 97 GTS N/A. What do you think about the following graph ? Your data are similar or not at all ? Air temp Ign Corr table : Coolant Retard table : Air Temp Fuel corr table : Be aware that my X axle is on °C not °F, but the...
  3. C

    97 GTS Transmission : countershaft stuck

    True :) I'll try to pull it out and check it. Or I will send the all transmission to a pro and let his knowledge do the magic :)
  4. C

    97 GTS Transmission : countershaft stuck

    ok, does that mean I will have to change it as it could be damaged ?
  5. C

    97 GTS Transmission : countershaft stuck

    Thanks zombies, I try an even lift the transmission by the countershaft, wiggle it .. but all was holding by the shaft ! I have to try to hammer it then .... but I don't understand how this could get stuck like this.
  6. C

    97 GTS Transmission : countershaft stuck

    I was thinking also to go with a 3.55 but as I already spinning the tire in 1st and 2nd, I guess that would be not recommended :p
  7. C

    97 GTS Transmission : countershaft stuck

    Yes, as the transmission is (will be :p ) disassemble I will change the gears at the same time !
  8. C

    97 GTS Transmission : countershaft stuck

    Good point, I was fine tuning the car and on 5th and 6th the acceleration was slow enough to record the Air/fuel ratio. PS : I was driving and someone else on the passenger side had the laptop :)
  9. C

    97 GTS Transmission : countershaft stuck

    Hi everyone, My transmission "broke" on the highway, doing 5th and 6th full throttle acceleration. I start to disasembled my gearbox and found one broken key of the 5/6 synchro. As I continue to remove all the internal parts to make a full rebuilt (with upgraded parts), I cannot pull...
  10. C

    Idle pb with AEM engine management system

    Hi everyone. Since a few days I have a idle pb on my GTS 97 Viper. I have AEM EMS. My idle was perfect but a little bit too high (900 minimum), I start to modify the tune (I made it myself a few month before) and I suceed to lower it to 750rpm (I got cam, heads, 725cc injector, fuel rail...
  11. C

    oil circuit

    Right ;) But if I can install the sensor without drilling somewhere I'll prefer ;)
  12. C

    oil circuit

    Don't you think there could be the spring of the relief valve just behind this plug ?
  13. C

    oil circuit

    I would like to install a oil temp sensor. Do you think this plug could be remove to put the oil temp sensor ?
  14. C

    ODB2 connection problem

    Hi all, I have some problem with the connection to the ODB2. When I plug the innovate LM2 for exemple, to read TPS, RPM, fueltrim... It's show "connected", then " not connected" then "connected" and so on .... it's impossible to keep the connection "conencted" to log some data .... I do...
  15. C

    New Viper in France

    Here is a video between my viper and another one GTS FE with drag slick tires.
See more

Latest posts

Members online

Total: 805 (members: 4, guests: 801)

Forum statistics

Threads
153,199
Posts
1,681,921
Members
17,697
Latest member
rmoore8950

Share this page

Top