Hi,
I'm looking to buy a diffuser, can someone post good pictures of Autoform 4 blade rear diffuser? Did a quick search, but didn't find what I was looking for.
Thanks Mika
Hello all & thanks for your replies again!
Few questions... Because many of you have suggested I would need a dry sump, so I would like to know why would I need that? My knowledge about dry sump is based on the fact about g-forces during extreme cornering/acceleration where the oil level varies...
Moro Lauri,
Hi all,
I just came back from holiday, so that´s the reason for delay for my reply...
In the first post I wrote that I have full built engine...what I meant was full rebuild with major modifications. So for the rotating assembly there is only a crank which is stock item. Pistons...
Hello,
I have GEN1 -94 full built s/c engine but I want more rpm... I have now 708 cam but I want powerband to reach 7500-8000rpm.
Where would you suggest to look for a more aggressive cam for my engine? Any cam spec suggestions?
Thank you!
Hello!
Does anyone have any experiences running g-Force R1´s on mixed street/trackday use? I have quite lot of experience about Kumho and Toyo and they are ok, but I´m seeking a bit more grip so considering those g-Forces... But how they behave when used on street? Will they melt down much more...
Hello.
I measured the resistance from the solenoid pins and I got 13ohms... But I don´t know what to do with this information. :dunno:
Do you people have any other suggestions regarding this problem?
Hi,
I´ve been trying to solve the problem with my reverse lockout solenoid, but I cannot find any explanation for the behaviour it has. So here it is how it works on my 94 RT/10:
- key off: I can select reverse gear feeling some spring tension
- key on: Same as above
- cruising over 5MPH...
I´m looking for an information about the correct position of the hood vents? (center vent I have is the big GTSR vent and Gen1 car)
Can someone provide good measurements or some pictures under the hood with all three vents installed so I could verify the correct positioning of my vents...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.