The type of replies to the OP's original thread is one of the main reasons I am no longer a paying member. All you have to do is look at the replies to many other posts and it is always the same few.
I watch good morning america almost everday. Lately, they have had the ABC news fixer help people out with good results. I would contact them and see if they could help out, a google search will pull up the contact info for them. And it's free... This would be a good news story.
Per the other thread, not enough tickets were sold thus was a 50/50. I don't foresee another car raffle in the future since this one and the last one did not sell enough tickets.
I was finally able to remove the differential. The slide hammer did not work either. I purchased a ball joint fork but then had to use a press to expand the forks out then grind some more for it to fit around the axle shaft. After a few hits with the sledge hammer, they separated. I sent the...
I have never been to New Orleans so I figured this will be a good chance to go, so I have signed up. Let me know if you go and maybe we could meet up for the trip down there.
No, did not want to take the 1/2 shaft boot apart. Per my research, taking the clips off is not necessary.
I will try the slide hammer idea this weekend.
I am having my differential rebuilt but am having issues on getting the half shaft removed from the differential. I found an old post on the differential removal on here and they just used a prybar but I am having no luck with that method. I read another post where they mentioned Miller Tool...
My differential recently went out. Looking for a used setup with 3.55 gears already installed. My car is a 2006. I have been told a Gen 4 would be better. Thanks for any help/leads.
I sent my car to hennessey a little over 4 years ago and had it supecharged. I have put over 20,000 miles on the car since then and still running strong, even had the fastest 1/4 mile at the last VOI, it is also one of the best sounding gen 3 cars out there (hennessey exhaust). Yes, they have...
I installed the oem fluids which included the additive. Have not heard any type of whines. I will drain the fluid this weekend and see what it looks like.
2006 with paxton. Was driving back from a long road trip and just seem to notice a clinking noise when pressing the gas then letting off (not the typical viper clinking noise). Car shifts fine and no shifter movement. I put the car on the lift and motor mounts appeared fine. Havent taken the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.