Recent content by obaa996

  1. O

    Gen1 interior trim screws?

    Thank you Dean for the leads. I tried looking through them thoroughly, but couldn't find the correct fasteners. I'm hoping they were not a one-off type of thing, but they might be. I'm currently trying to find a parts manual and see if the part number might still be available. The screws look...
  2. O

    Gen1 interior trim screws?

    Hi, Would anyone happen to know what kind of screws are used for a '94 RT/10? Particularly the screws for the lower dash kick panels and center console? The local dealer has no clue. I went to NAPA and found some screws with the correct head shape ("Balkamp 665-1350 Phillips flat top washer HD...
  3. O

    Second Gen RT/10 color/spoiler question

    Mopar did offer a spoiler for RT/10s as an aftermarket accessory (I have one), but I'm pretty sure it wasn't available as a "factory" option; perhaps as a dealer-installed option?
  4. O

    AC condenser line; "upper air baffle" removal?

    Starting a separate post in case anyone recognizes the part description... I'm trying to get access to the passenger side ac condenser line in order to replace the o-ring. There is a part "upper air baffle" (#4; 4709 403) which is blocking access, and I do not see anyway to remove it, nor has it...
  5. O

    Gen1 front fascia removal hints?

    Just to update/close this out... There is a ***** and Christmas tree fastener holding the fascia under each headlight. They are a minor PITA to get at. The overflow tank is common to the D150 pickups and other trucks. I put some tape marks on the tank so I could directly check the level from...
  6. O

    A/C oring sizes and source?

    So, it does look like the condenser outlet is where my leak is occurring; the stain is pretty obvious under the black light. However, I don't see anyway to get to it. At this point, the front fascia and radiator have both been removed, and there is no access to get to the line. There is an...
  7. O

    replacement radiator alternatives?

    Hi all, So in another thread, I was trying to remove my front fascia to get to the overflow tank (currently stuck trying to remove stripped s*c*r*e*w under headlight). So while I was at it, I flushed the cooling system. Long story short, I found out the radiator is weeping, and needs to be...
  8. O

    1994 RT/10 Fuel pump not working?

    relays are pretty easy to check. Parts shops may have a relay checker; basically a board with different relay sockets you can plug the relay into. If not, you can check them yourself with a meter and battery; google "relay pin diagram" with the pin numbers on the relay (probably...
  9. O

    Gen1 front fascia removal hints?

    Apparently, the letters "s", "c", "r", "e", and "w" are not allowed to be strung together, even when the combo refers to mechanical attachment device.....
  10. O

    Gen1 front fascia removal hints?

    I found out what my issue is/was. So, there is another one of those Xmas tree plugs and a ***** in the fascia, under each headlight; I'm really glad I did not just try to yank the thing off! The ***** is under the Xmas tree, which makes it hard to turn(there is no straight shot to the *****...
  11. O

    Gen1 front fascia removal hints?

    I really didn't intend to get this far into it.... In a previous thread, I had asked about oring sizes for the AC condenser (thanks again Steve!). This weekend, I started pulling out the radiator to get the condenser, when i noticed a coolant leak. One thing led to another, and I ended trying...
  12. O

    A/C oring sizes and source?

    Hi Steve, Thanks for the quick reply! I didn't see that brand specifically at the AutoZone site, but found this: https://www.autozone.com/cooling-heating-and-climate-control/a-c-system-o-ring/p/surebilt-auto-a-c-system-o-ring-set-240-piece/540059_0_0 which lists both the sizes that you...
  13. O

    A/C oring sizes and source?

    I'm awakening my '94 after a long hibernation (8 yrs?). I knew there was a refrigerant leak in the a/c system before it was put away, and would like to track it down. I suspect the leak is by the front condenser, but will be verifying with a dye test. In the meanwhile, I'm trying to hunt down...
  14. O

    Autocross!

    For anyone interested, there is a website that shows a lot of the regional autocross events (SCCA, ORPCA, BMWCCA, etc.), including location and registration requirements. You can also register for most of the events online as well. For those who haven't been to one, it's an excellent chance to...
  15. O

    HEAD GASKET UPDATE, Gen-1 Guys Look Here!

    Thanks Dan; just put in my order!
Top