Recent content by tarfungo

  1. T

    Seeking Viper Billet Polished Gauge Bezel Trim Rings

    Hi!, Looking for a set of RT/10 Gen 1 dash billet polished gauge bezel trim rings. Does anyone one know if something like these are available from anywhere? http://tinyurl.com/a5cyjaz http://tinyurl.com/a8cvnnw Cheers, Greg
  2. T

    Seeking a solution / vendor to cover dash?

    Nice! That's EXACTLY what I had in mind... I'll give Venzano a call!
  3. T

    Seeking a solution / vendor to cover dash?

    Hello, Any one know of a supplier that provides services or a DIY kit to cover a Viper dash and center console bezel with vinyl or ??? I'm not looking for carbon, simulated wood or anything super bling, but rather just a simple gray (or black) vinyl glued (?) on covering? I have three OEM...
  4. T

    San Francisco Bay Area CA Viper owners: Where do you get your snake serviced?

    Just curious where San Francisco Bay Area owners are getting their snakes serviced? Regular maintenance and small repairs specifically? Not many dealers around these parts these days. I'm looking at a 30K maintenance stop. Dealer in Richmond CA is saying to expect $800 to $1200! Yikes...
  5. T

    What an untitled 94 RT/10 worth?

    The car is 'essentially' still on the showroom floor. It still has the factory sticker on the window listing it for sale at $57,000. It’s one of those, “What will you give me for it?” things – hence why I’ve come to you all. 99 R/T 10: Would that be true that the warranty would not be...
  6. T

    What an untitled 94 RT/10 worth?

    Oops, sorry. Red.
  7. T

    What an untitled 94 RT/10 worth?

    Hello, What would a untitled 94 RT/10 with 900 miles be worth? NOS at dealership. I assume since it’s untitled it comes with a full warranty? Thanks in advance.
  8. T

    Windshield surround paint

    Hello, The paint at the corner point where the A-pillar and the top of the windshield meets has worn through to the primer (white?) on my RT/10 as a result of the using a hard top over the years. The defect is a little smaller than a quarter on each side (drivers and passenger sides), but...
  9. T

    Any Bay Area Viper heads????

    San Rafael
  10. T

    Service Engine Soon Light

    Batboy, Don’t know if this will help, but I recently had my ‘check engine’ light come on while burning down the highway. All seemed fine, but I pulled over just to check. Couldn’t see anything, so I restarted and the light was gone. Took it in for service and it turned out to be an air...
  11. T

    Gen 1 fuel leak???

    Hey Chad, Tried your suggestion... filler tube screws appeared to be tight, but I torqued them just for good measure anyway. I don't think this the problem, but I'll keep an open mind and hope that your suggestion does the trick! Thanks for your thoughts!!! Cheers!
  12. T

    Gen 1 fuel leak???

    Ha! No problem. All you do is stop at every gas station along your route and top off. This way you never spend more that 5 or 6 bucks at any one stop! (I live in California, so 6 bucks equates to just shy of two gallons!) But seriously... Hey Chuck, Thanks for the response. I found the...
  13. T

    Gen 1 fuel leak???

    When my Gen 1 tank is full (and only when completely full) and parked at a slight side-to-side angle, like on a public street with a normal street curve for rain run off, fuel will puddle just behind the right rear wheel. I suspect that this has to do with the filler neck. (?) Anyone had this...
  14. T

    Melting Gen 1 Headlight Switch...

    Thank's Viper Jay! :2tu: I’ve ordered one of the upgrade cables and we’ll see how it goes. Does anyone know what the DC part number is for the female connector? I’ve checked with the folks that make the third party headlight switches that AutoZone and Kragen sell, but these folks don’t...
  15. T

    My Gen 1 needs a new fuel pump… what are my options?

    My 95 RT/10 needs a new fuel pump. Cranks at startup and getting worse. Dealer confirms and says its $1050 parts and labor. Anyone know what the actual parts go for and how much of this is labor as I suspect that my dealer is not offering any parts discounts?
Top