Search results

  1. Tom and Vipers

    GTS Dipstick: need Distance from FULL mark to top of dipstick tube

    The part number stamped on the dipstick should be 4763791AC or AD (97 to 02 - NOT 96 GTS) Thanks Tom
  2. Tom and Vipers

    Best place to tap onto battery voltage:

    Was planning on the M10 power stud on the main fuse box but saw some articles of ways to tap using "tapping" fuse adapters. Not keen on adding load to an existing fuse but something like cigarette lighter would be a candidate. Are there any unused fuse or relay stations that have battery on one...
  3. Tom and Vipers

    Gen 2 Window Regulator Clips: Now 2 Types: Which???

    The new ones have "fingers" to keep window pin in center of slot. The old one did not. QUESTION: Use "fingers" or grind out? QUESTION: Anyone make higher quality ones? (These cost $8 shipped from Amazon - why pay $20 for garbage when you can pay $8 LOL!) These are everywhere on eBay FOR...
  4. Tom and Vipers

    Gen 2 Regulator Shuttle / Clip: Are there better ones?

    They are everywhere for cheap. They seem to break. Was OEM better? Is there a better quality out there? And what are these black ones?
  5. Tom and Vipers

    Gen 2 Window Regulator Clip Shuttle Replacement: are there good ones?

    These clips are everywhere for cheap on eBay, etc. Is there a better grade available? (wouldn't be surprised the OEM used a different material like fiber reinforced nylon instead of just plain) Also wondering if I'm doing something wrong having replaced 3 LHS and 1 RHS on my 96 GTS over the...
  6. Tom and Vipers

    GTS parts manuals pdf

    These existed many years ago, I think thru Roe Racing. There may have even been CD's. I need parts manuals for 1996 and 2002 GTS: part numbers for oil pan, dipstick tube and dipstick. Thanks Tom PS. I had these but I'm pretty sure they went bye bye when my HDD crashed on my primary computer...
  7. Tom and Vipers

    Using E85 for the Nitrous Wet System - Timing Considerations

    Still trying to figure out how to pull a few degrees for a 150 shot in a 1996 GTS PCM. So far there isn't a clean solution. (I don't think there is a Lingenfelter "LNC-2000" for Viper.) Then it occurred to me if E85 was used instead of gasoline (car remains fueled on gasoline) for the wet...
  8. Tom and Vipers

    96 GTS Plugs: Using Champion rc12ecc instead of rc12lyc

    Both plugs look identical. What is the difference?
  9. Tom and Vipers

    1996 GTS fuel pump replacement options: 255 Walbro and Mat?

    I'd love to find a 2-stage pump but that is a losing proposition. Aftermarket units are not 2-stage and the OE is only 190 lhp which is pretty wimpy and very unattractive considering used prices of a module ranging up to $1500. A Gen 3 pump (255 lhp) would be a no-brainer but I don't think...
  10. Tom and Vipers

    What is a 963318 stamped 852 cast cam?

    961138 stamped on the end 852 cast in the base circle Thought it was a stock cam removed but looks like it has big lobes.
  11. Tom and Vipers

    1996 GTS Last minute headlight maintenance

    I'm days away from driving GTS from NV to home in PA and finally got around to checking headlight pattern on side of building. Not only were the lows weak (and the highs decently bright), there was no similarity whatsoever between the light pattern between the L and RHS headlights. IN...
  12. Tom and Vipers

    NEED Fuse Box Cover for 1996 Viper GTS

    Long story short: mine got run over. Dimensions: 6-1/4 x 3 x 1-1/4 with a small notch at a corner. Hoping to leave NV Sunday driving car home to PA - hoping not to resort to Saran Wrap.... (car does not have hood part of the inner fenders) Thanks https://imgur.com/a/ox1NCJ7
  13. Tom and Vipers

    FREE: 1996 GTS OE Take Offs Exhaust Manifolds amp pipes Flywheel Clutch Cam Rotors

    Parts were removed from 1999 to 2001 and have been on the shelf since: $150 Exhaust manifolds $200 Stock cam $200 Stock Rotors Set $150 Flywheel $150 Clutch & Pressure Plate $350 Stock exhaust cut in pieces for removal also 4 335/30r18 Michelin MXX3's 2 on the wear bars but not bald, 2 with...
  14. Tom and Vipers

    Mail ordering dealer O2 sensors for 96 GTS: any chance getting wrong connector type?

    Seems each generation has a unique connector type. (this sounds very problematic if I need extensions for my long tube headers.) Car in NV and I'm in PA and would like to have parts mail ordered and waiting for me when I show up. I was hoping to order from a dealer that gives discount rather...
  15. Tom and Vipers

    96 GTS: Heater/AC: Low Vent Flow Velocity: Possible causes?

    I'm in PA and will be fixing car in NV so just trying to some homework. Blower motor sounds like it is running properly Proper vents active for Heat and AC but flow is very low No sound of "rushing air" in high speed If I had to guess: Something restricting the blower inlet Blower cage fan is...
  16. Tom and Vipers

    O2 Cable Extensions: Yes or No?

    I have headers and wonder if I should get Cable Extensions for the front OE O2's or just make up the distance with soldered wire? With extensions, now 2 connector integrities required for good signal. Soldering is the BEST. ....but soldering is a RPITA.... EDIT: OH GREAT: "Oxigen travels...
  17. Tom and Vipers

    Any Dodge dealers sell discount? Need OEM O2's.

    I have no cats, so I think junk rear O2's is a non-issue, but the fronts have to be proper. I was thinking of Woodhouse. There are dozens of places like allmoparparts, dodgeparts, moparonlineparts, factorychryslerparts, etc. etc. ad infinitum that I wouldn't trust to get true OE and not MOPAR...
  18. Tom and Vipers

    Upgrade OE 275/35r18 to 295/30r18: PRO/CON

    Any advice would greatly be appreciated. Thanks in advance, Tom
  19. Tom and Vipers

    Need Link or Pics to GTS manual door release

    Friend has to move car, KeyFob not opening car. Need to explain how to get in through back window. Reason I need pic is that the roll bar makes it virtually impossible to reach or see the latch. Just a pic would suffice. I thought it would be an easy internet search but NOTHING - I'm...
  20. Tom and Vipers

    Last post here is over 3 years old?

    How is that possible?
  21. Tom and Vipers

    1996 GTS Latest Factory Flash Before SCT Flash

    SCT recommends getting latest factory flash before flashing tune. The closest 4 dealers cannot flash a 96 GTS. They no longer have the DRBIII / WDS to do the flash. They could not tell me what flashes are available - but if I bring the car in and they hook up to it, they will get a list of...
  22. Tom and Vipers

    CRAZY UPS Rates Promotion

    Long story short: Ground Residential is 30% discount, Ground Commercial is 38% for 1-20#, more discount for heavier weights. International is 61%. Have to signup by Monday. Rates stay in effect to 2044 Below is table data copied - if you work at it, you can navigate it with the above...
  23. Tom and Vipers

    Latest year a DRBIII can be used on?

    Friend wants to use mine on a new Challenger. I said it won't be of any use. Who is right?
  24. Tom and Vipers

    Door Panel: Aft edge pulling away from door then catches on weather stripping

    Both sides. Seems there is only a screw on the bottom and just the snap over the inner sheet metal at the window opening. And it really doesn't want to go solid against the inner metal when pushed either. Seems fasteners along the aft edge are needed.
  25. Tom and Vipers

    Hot August Nights: Sparks, NV Tuesday Cruise for late model

    HAN is a big deal here. But it is aimed at <1977 cars. However, there is a cruise (yes, cruising the main drag) in Sparks NV on Tuesday, August 8th. It is along the main drag, Victorian Ave. from 15th street to Pyramid. I'll be there in "Bad Viper" 96 GTS, all black w/red stripes.

Latest posts

Members online

Total: 359 (members: 11, guests: 348)

Forum statistics

Threads
153,182
Posts
1,681,808
Members
17,680
Latest member
RonK

Share this page

Top