thanks for the information, I need to confirm all recalls are sorted after I get the vin , if not probably best to get a later build year if the pound ever improves.
thanks ,my biggest concern is the motor, do you know after a certain mileage the motor is proven to be ok or can they fail any time?
I don't think a Chrysler warranty is available as it is an import .
thanks ArnarFB , that is fine. the carbon fibre rear painted the same color looks better in my opinion
the viper red is a non metallic as far as i am aware. if you get a chance check out the red on a final edition red/white stripe 2002 gts
huge improvement, that will stop the leading point of the hood above the light unit getting boken off as i have seen on a couple of gen 2 cars in the past.
owners , mechanics or similar must walk past them when hood in open position , their pockets or similar must catch on the corner .
I have srt calipers front and rear with yellow stuff pads on my 97gts with willwood prop valve, is there any advantage in fitting the SRT master cylinder ? I find the conversion far better than stock, no front lock up but think there is still room for improvement.
I went for a drive to buy beer 4 years ago in my old car 12000 mile 99 gts, opened my drivers door and heard a cracking noise.
what a nightmare , the door stuck open and would not close. ( the lug on the door went past the broken spring and locked behind it with no way of forcing it back...
thanks!
are the measurements ID or OD on these headers ?
will they throw a check engine light ?
do the exhaust ports match up well to both size headers ?
if I fit the 1 3/4 " with the intention of further mods but end up not getting further mods done, will it spoil the way the car drives ...
i want to fit a new set headers on my 97 gts .
i have a 3" corsa cat back.
k and n and smooth tubes.
can anyone tell me if the 1 3/4" acrx headers will be suitable or are the 1 5/8" a better bet ?
i am thinking of fitting the larger diameter in case i want to tune the car more in the...
i have a 97 gts 9,000 miles
hi flow cats
3" corsa catback
k and n panel filter
smooth tubes.
any ideas what are the best headers to go for, i had bellanger on my last 99 gts but there might be better ones out there ?
also roller rockers . i need to know what are the best ones out...
i am fitting daves big brake kit ( srt calipers front and rear )
i have srt rotors on front, gen2 front rotors on rear.
please can anyone give me an approx setting for the adjustment knob on the willwood prop valve before i test the car?
thanks!
yes, i was after an adapter to connect the willwood smaller threaded hole to the larger 97 gts rear brake line.
i think i have one sorted but will not be 100% sure until it arrives.
do you know the exact size fitting required ?
thanks!
i am fitting a Wilwood prop valve to my 97 gts and need to connect it to the lower brake line ,the largest one closest to the windscreen that comes up from the chassis from the rear of the car.
please can anyone confirm the exact size of the fitting at the end of this pipe that screws into...
i am actually trying to fit one at present. there is restricted room to change one ,if you have fingers like jumbo sausages it might be a problem.
it is a willwod prop valve with my daves big brake kit and have noticed the out port of the prop valve is too small to take the 97 gts brake line...
please can anyone give me the torque settings for daves big brake kit, i need to know what torque for each bolt and is loctite required on any of them ?? thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.