I have pumped that pedal so much over the last 3 years trying to bleed 8 slave cylinders... it Doesent seem to work on this car lol we used the mity vac and when we install a new slave cylinder every time there is no pedal at all at first takes about 20 pumps to even make pedal half hard...
No that’s not it! It gets softer the longer your drive it starting and stopping in the heat makes it worse! Seems like air gets introduced to the system but no fluid ever leaves..
Got a 02 gts and it’s been going on a few years now trying to chase this issue. Originally took it in for a rear crank seal leaking and replaced everything, clutch slave and resurfaces flywheel. when I got it back pedal was soft. So figured took to much of fly wheel and ended up ordering a...
Ok it was working great all along for the last few months.. Just wondering why it got soft all off a sudden?? Anyways it's either the slave cylinder or Maby the line I did notice it wet up a little higher past where the quick connect goes on... I'll have a new slave and put in when i take...
Well the fluid is a dark grey colour.it was bleed fine all along but just the drive the other night it got right soft and engagement was really close to the floor still engaged fine and shifted fine but pedal was really soft and close to the floor it did look like some oil down by where quick...
I had tranny apart last summer and put a new clutch kit and slave cylinder in. now i just had tranny out again and put another new clutch kit in and a new input shaft. and last night i was driving it around and noticed some tranny fluid leaking from inspection cover,,, i must have torn the seal...
Got a 02 gts had a rear seal leaking so got a new stock luk clutch and new slave cylinder . Figured while they were in there do it all at once right. Now the fly wheel looked glazed from heat n oil so had a shop next door re surface it . All back together and it works great except for a big...
These mounts will not last in our vipers with no heat shield on the end of the mount towards the exhaust! I just put a set in last summer from Roe racing and the mechanic I used put my passenger mount in backwards so he heat shield was facing forward and the mount melted right out!! So with no...
I have a rear crank seal leaking going to take it into my buddys shop and use there lift to work on it, now I want a order a new clutch cause this one is covered in oil.. and have to take tranny out anyways to change the seal, I know its not a stock clutch in the car. Its very hard to push the...
Had my 02 GTS into shop Friday oil pan gasket was leaking and got that fixed now The rear main seal is leaking ... My question is does the oil pan have to come back off to change the rear seal when you have the transmission out???
On the rear of my 02 gts the ball joint looks like it's up a 1/4" out of the control arm no one has a ball joint in stock for a viper, what other vehicles takes the same rear lower ball joints?? Thanks a lot guys!!
I said screw it and ordered one anyways!! just to have fans come on a little earlier in the srt8 made a huge difference so see what it does in this, and to have them come on after motor is shut down for a bit is a great idea too. dosent look to hard to hook up is it?
Ya in my srt8 jeep I have the diablo predator and I can make my fans come on sooner and stuff made a huge difference in it!! It don't run hot unless farting around in heavy traffic when really hot out!!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.