For a 94 rt10 what is this part called. What is the best source in getting one? Mine wore through the bushings then the metal over a quarter inch. It was ok until I put in a new clutch,slave,and master, but I think the thickness of the new disc will not allow me to get into any gear with the...
Hi, I have followed the service manual(1994)to remove the trans, I had some trouble with the slave disconnect that Tom helped out with.:). I lowered the motor/trans as far as I can and the trans only comes out about 3/4" then the housing hits the passenger side frame and I am stuck:crazy2: Any...
I'm dropping the trans and at the step to disconnect the quick disconnect for the slave cyl..I don't have the special tool, is there an alternative? Thanks in advance!
If anyone has had a clutch master cylinder fail, what are the symptoms? Sometimes I can't get into gear without a clunck, then other times fine. I have no fluid loss at the clutch MS reservoir,and nothing on the floor. Tranny shifts fine with the engine off. :dunno:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.