Search results

  1. O

    how to adjust clutch

    My experience is that your slave unit is going and your clutch is not fully dis engaged when your are shifting. Check for oil under your bell housing.
  2. O

    Bigger Rear

    Does anyone make a bigger caliper for the rear that works with the stock 13 rims? I know about Toms 42mm caliper but what else is there? I took a drive hitting the brakes alot. The fronts were nice and hot but the back claipers were barely warm...obviously they arent doing any work and I removed...
  3. O

    Always Hard.....

    Does anyone make a bigger caliper for the rear that works with the stock 13 rims? I know about Toms 42mm caliper but what else is there? I took a drive hitting the brakes alot. The fronts were nice and hot but the back claipers were barely warm...obviously they arent doing any work and I removed...
  4. O

    Always Hard.....

    I have a 1995...is that as far as yours moves...about an inch?
  5. O

    Always Hard.....

    Pushing the pedal while starting the car it moves down maybe an inch but then its hard as a rock. My other cars Vette, Mustang etc go almost to the floor with the same test.
  6. O

    Always Hard.....

    No this is not a thread about Viagra :) I have a brake problem. I have recently updated pads to HPC street Hawks and new rotors drilled and slotted. I bed the pads but the brakes still do not feel right. One issue is that I dont know how they are supposed to feel. How much travel should be in...
  7. O

    Brake Improvements

    Hey there ViperJohn....I am a little South of Glen Burnie...near Ft Meade actually. I have recently updated pads to HPC street Hawks and new rotors drilled and slotted. I bed the pads but the brakes still do not feel right. One issue is that I dont know how they are supposed to feel. How much...
  8. O

    Brake Improvements

    I heard that Toms 40mm were not available anymore? Anyone ordered any recently and received them?
  9. O

    Brake Improvements

    I just finished installing a supercharger on my Gen 1 (1995) and now the stock brakes ae really scary :) I have stock 17 " wheels and stock brake components. This is for the street only but with the stock setup I feel like I am not going to stop. I know about Toms 40mm rear brake kit but I think...
  10. O

    Removing tranny

    I am in process of replacing leaking clutch slave in my 1995. I have all 8 bolts off from the tranny to bell housing and a jack under the oil pan and tranny jack under the tranny. I can not get the tranny to "slide out". If I wiggle the tranny from the drive shaft end, the whole engine wiggles...
  11. O

    Where to buy rubber boot

    Replacing my clutch slave on my 1995 and I found that my rubber shift boot/seal underneath the center console is torn up. Anyone know where I can pick up a new one? Tx all
  12. O

    Sourcing Obsolete Parts For Gen I and Gen II Vipers

    Looking for GEN 2 passenger air bag cover.
  13. O

    Fluid from my Tranny

    My 1995 with 68K just developed a leak coming from the center of the bell housing. Its from the hydraulic clutch. I checked where the line from the clutch master goes into the tranny case and its dry there. Is there a magic solution here or is this remove the tranny and replace something?
  14. O

    Ignition Wire Fit

    I bought a new set of ignition wires for my 1995 Gen 1. They are Mopar p5007309. I started installing them but the lengths are wrong on some of the wires. Are Gen 1 wires different then Gen 2..its the same engine??
  15. O

    What belt for Paxton

    any ideas???
  16. O

    What belt for Paxton

    My 1995 has a Novi Paxon on it. Does anyone with similar install know the part number for the serp belt for the supercharger?
  17. O

    please help me decide on stripe pattern

    Anyone have a source of vinyl stripes for Gen 1? Mgeorge where did you get yours? I am in Maryland.
  18. O

    Looking for supercharger

    Either Roe or Paxton
  19. O

    Looking for supercharger

    Looking for low mileage super charger system for Gen 1 1995
  20. O

    WTB supercharger system

    Looking for low mileage super charger system for Gen 1 1995
  21. O

    Chrome Valve Covers

    Looking for Chrome Valve Covers that will fit Gen1.
  22. O

    Sourcing Obsolete Parts For Gen I and Gen II Vipers

    Chrome valve covers to fit Gen 1
  23. O

    Valve Covers

    Does anyone know where I can find chrome valve covers for my Gen 1??
  24. O

    Fan upgrade

    Interesting...so why do most power kits also include a lower temp stat if its a bad thing?
  25. O

    Fan upgrade

    Suppose I install a 170 thermostat. How does one change the temp that the electric fan comes on a 1995? Newer cars are controlled by ECU programming.

Latest posts

Members online

Total: 745 (members: 11, guests: 734)

Forum statistics

Threads
153,190
Posts
1,681,855
Members
17,685
Latest member
Lennatave

Share this page

Top