I have just been looking over the front of the SRT, and I am curious to see what the front end looks like with the following change;
If you look at a front 3/4 view of an SRT, you'll notice the front end actually points "upward" on the lower section, resulting in the front of the car looking much higher than it really is. What I would like to do is flatten out that angle, making it parallel to the ground, lowering it slightly as well. This will result int he front end looking lower, as well as increasing the size of the air dam- more airflow cant hurt. I think this is one of the MAJOR appeal differences fron the SRT to the CC, as the splitter on the front mimmicks (to an extreme) to which I am refering. Anyone want to give it a go? If it looks as good as I suspect, I cant see why an aftermarket wouldnt jump on board- half the work is already done with the OEM bumper, just modify one to make the new mold.
Also, a lowered chop of the same thing as well please.
Thanks to anyone who gives it a shot.
If you look at a front 3/4 view of an SRT, you'll notice the front end actually points "upward" on the lower section, resulting in the front of the car looking much higher than it really is. What I would like to do is flatten out that angle, making it parallel to the ground, lowering it slightly as well. This will result int he front end looking lower, as well as increasing the size of the air dam- more airflow cant hurt. I think this is one of the MAJOR appeal differences fron the SRT to the CC, as the splitter on the front mimmicks (to an extreme) to which I am refering. Anyone want to give it a go? If it looks as good as I suspect, I cant see why an aftermarket wouldnt jump on board- half the work is already done with the OEM bumper, just modify one to make the new mold.
Also, a lowered chop of the same thing as well please.
Thanks to anyone who gives it a shot.
