S
serafins
- Posts
- 54
- Reaction score
- 30
Latest activity Postings About
-
-
Sserafins replied to the thread New Intermittent Whirring Sound - Clutch?.Likely throw out bearing but really could be any part in the driveline. Driveline harmonics will travel throughout the frame. if not...
-
Sserafins replied to the thread Oil Cooler, feedback or thoughts on this one? MHX-248.Doubt that it is needed. These cars have a pretty massive oil cooler from the factory. Maybe take the system apart and have it flushed...
-
Sserafins replied to the thread Front fascia alignment.Here's the finished product (for now, until I get around to dropping my hood hinges - but that's another story. The passenger side hood...
-
-
Sserafins replied to the thread Front fascia alignment.So I ended up getting my fascia just about perfect. Still have to mess with the headlights. Honestly, the guides were a good reference...
-
Sserafins replied to the thread Tach Slow / Lagging.Did you get a NOS tach or just another used one?
-
SThe tach in my '99 is very slow to sweep when revving. When driving aggressively to redline, it shows about 5k rpm at the time I hit...
-
Sserafins replied to the thread Does anyone know where I can buy the center council support wedge?.foam workout mat cut to fit does a fine job for $10 or so and 20 minutes of time. That's what is under mine. The rattle and squeaking...
-
Sserafins reacted to GTS Dean's post in the thread Does anyone know where I can buy the center council support wedge? with
Like.
My car has no such thing as built. -
Sserafins replied to the thread Gen 2 track thoughts.Thanks gentlemen. Yes I did do some relocation work already and wrapped several lines in heat shield. Happy to report the clutch...
-
SThose SVSi headers are NOTORIOUS for burning, melting and boiling everything near them. You absolutely MUST use heat shielding (not just...
-
SYes, with those headers you need to route a couple of the wires in special way and use heat boots. On the passenger side route the plug...
-
Sserafins replied to the thread Advice on Engine Build Gen 2.Thanks Dan. Very helpful. I was hoping you'd chime in as you set this car up for the original owner and it still runs great 25 years...
-
SThe GTSR heads cool well and have little core shift, so they can be ported fairly well without the exhaust ports cracking, but they...
-
SGoing to be putting together an engine for my Gen 2 this winter. I have GTSR heads that were ran at Lemans. These are the big port...
-
Sserafins replied to the thread New Owner of 2002 Final Edition.I wasn't aware the FE had different stitching. What is it supposed to look like? Red? I have a stock knob for a later Gen 2 I'd let go...
-
-
Loading…
-
Loading…
