Gerald
Enthusiast
I've searched and searched but all I'm reading is drill the hole out. Which hole do I drill out and how big do I drill it out to.. ?
Thanks
G
Thanks
G
Installing K&N, question
- Thread starter Gerald
- Start date
Viper IV
Enthusiast
I'll sell mine for 1/2 price $150 + ship if anyone is interested. Holes are already drilled.
Rob
Rob
Gerald
Enthusiast
left as in looking at it from the front of the car? or from the drivers seat? :LOL:
This has 3 holes in it. Looking from the front of the car head on. 2 Holes on the left side, and 1 on the right.. Ones on left side are 3/8" and larger one is 7/8".. Angled ****** on right is a little larger than 3/8"...
Are they already the correct sizes?
G
K+N is doing a test dyno car (again) this week, generously loaned by one of our customers. They plan specific varied hole size dynos, but they swear by the 3/8 PCV line opening (Left Side Of Car, right-angle straight out) and doubt that bigger is better. But THIS time its a 1-goal test. Making sure of the optimim hole size.
They do admit that some early units did get out w/ smaller holes, and they have EXCHANGED those for our customers who discovered this and preferred exchange to self-service.
Please stay "tuned"
They do admit that some early units did get out w/ smaller holes, and they have EXCHANGED those for our customers who discovered this and preferred exchange to self-service.
Please stay "tuned"
Chuck 98 RT/10
Enthusiast
Alot of people have installed the filters upside down. Don't make that mistake.
Kai SRT10
Enthusiast
This is a joke, yes?
Gerald
Enthusiast
Yes, it's a joke.. They're round.. LOL!!
It seems mine already have the holes drilled out to the correct sizes then.. ????
G
It seems mine already have the holes drilled out to the correct sizes then.. ????
G
Chuck 98 RT/10
Enthusiast
Damn.
Tell the truth Gerald, you thought about it for a minute didn't you.
Similar threads
