Wanted: Old or bad V10 valve covers

OP
OP
1

1TONY1

Enthusiast
Joined
Dec 19, 2001
Posts
5,661
Reaction score
0
Location
Dalton Ga. (Chatt. Tn.)
Thanks guys. After a roller rocker or lifter or pushrod install or change, it is good to observe oil flow. With out something on the bottom side, oil will run down onto the head/block/exhaust. This can be stopped with cardboard and rags but it would be better with a ******* valve cover. I really hate to cut up a good valve cover. A burnt or beat up set of covers would be better to cut up. I could make a shield out of aluminum to bolt to the bottom set of bolt holes but thought I would see if there were any damaged stuff first.
 
OP
OP
1

1TONY1

Enthusiast
Joined
Dec 19, 2001
Posts
5,661
Reaction score
0
Location
Dalton Ga. (Chatt. Tn.)
From 2004......I think it was David Weaver from A.R.T that sent me a set. I use them frequently and think of David every time !!! Thanks DW. Used them yesterday.
 
OP
OP
1

1TONY1

Enthusiast
Joined
Dec 19, 2001
Posts
5,661
Reaction score
0
Location
Dalton Ga. (Chatt. Tn.)
You must be bored, and on a Sat. night?! Don't you have a car to work on...................................:D :D


This is true...the better half is at a b-day party.
The white car was burning fuel yesterday and today ;) Chad was my helper today...I think he is excited to be close to on the road again.
 

Viperchad

Enthusiast
Joined
Aug 18, 2004
Posts
393
Reaction score
0
Location
Pittsburgh, PA
This is true...the better half is at a b-day party.
The white car was burning fuel yesterday and today ;) Chad was my helper today...I think he is excited to be close to on the road again.

You have no idea.....cannot wait man. Even more excited to see the beautiful scenery again. Thanks again for a great day brother!!! Still searchin for the rear exhaust section.:headbang:
 
Top