Help with re instal of tranny

Mamba52 · Nov 22, 2012

Ok so I have the new flywheel installed and for some reason the tranny will not go all the way in. It slides in but the last inch it just stops. It feels like it hitting something. Any help would be great!!! Thanks Shawn

bluesrt · Nov 22, 2012

get back on the rear of tailshaft with both hands and rock up and down with good force pushing in, another try lastly is(you need to be careful) is instal bolt on each side and gently install bell houseing bolts back and forth,side to side in small increments and it will fall into place

happy56 · Nov 22, 2012

Sounds like clutch disc is not exactly centered and the front of tranny is not going into pilot bushing

Mamba52 · Nov 22, 2012

happy56 said:
Sounds like clutch disc is not exactly centered and the front of tranny is not going into pilot bushing

That's what it was. Removed bell housing and clutch. This time I made sure the clutch tool moved in and out smoothly and did a test fit with the bell housing removed. Thanks for all your help!!!!!

Viperless · Nov 23, 2012

I had the same issue and I didn't touch my clutch. Just swapped the trans. I struggled trying to get that thing in for a couple hours. I tried everything. Finally took a break cause I was about ready to throw something across the garage. Came back a while later and it popped right in. LOL

happy56 · Nov 24, 2012

Any of us that have worked on cars know that sometimes you have to walk away!!!!

tbsviper · Nov 24, 2012

Reading this brings back fond memories of wrenching on my cars in my youth....those were the good ole days!

Help with re instal of tranny

Mamba52

Enthusiast

bluesrt

Enthusiast

happy56

Enthusiast

Mamba52

Enthusiast

Viperless

Enthusiast

happy56

Enthusiast

tbsviper

Enthusiast

Similar threads

Latest posts

Members online

Forum statistics

Share this page