You will need to mod the breather outputs on the Gen 3 covers as they breath out the top and not the front..
Also you will need to mod the way your wire clips work.. I screwed in some threaded bar,put covers over and used SS nuts to secure covers and then pushed wire clips down on the threaded bar (like the Gen 3..
Re-use your Gen 2 gaskets on the heads to spacer as the Gen 3 covers have a seal built in...
The only issue i had was contact with the Roe intake tubes....
I used SS button head allen bolts to dress it up a little...
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images
You must be registered for see images
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images
You must be registered for see images
You must be registered for see images
You must be registered for see images
