Separate names with a comma.
What year snake?
Lol on the alcohol & vaseline
I took my leather boots from both shift knob and ebrake and used the Lexol Leather Conditioner. Massaged them real...
What year Viper?
What is your current exhaust setup?
What do you think about the overall sound quality of the current setup?
What do you think...
Why the mixed emotions?
Do you mind me asking what you are raising $ for?
Did you consider selling any/all of these cars privately?
Springs lower an inch
You could give aftermarket Caps a try wich only lower 1/2". These are just the things that slide in between the upper...
Clean the IAC Valve.
Replace the battery.
Putting that stuff in your tank was likely unnecessary . Unless you fuel up at non-top-tier gas...
Polished Aluminum HRE's here.
I drive 5,000/year
My regimen is:
- Wipe the brake dust off of them every other drive(or so) with a microfiber....
I dont think the tune is your problem.
Attempting to make sense of City mpg is a waste of time IMO. It is not easy to realisticly compare to...
What year is your Gen2?
You might want to run the first heat as-is since that is what you are familiar with & used too.
Then, 2nd heat crank them up halfway to setting 9...
FYI, This is how silly 20's look at stock ride height.
Notice the 4x4 look as well as the lack of tire sidewall
IMO Lowered 1" with 18F / 19R Looks the best:2tu:
I like having a little bit of sidewall to keep clean and think that it makes a car look...
The total cost to put a weak(relatively) gen1 motor in a Gen2/3 salvage could be similar just buying a Gen2/3 that was in an accident and just...
check the boot
and dont be surprised if it splits again a year later.
Mine did... :-(
I live in DE and havnt heard of that place.
What is the full business name and/or address/website so that i can check em out.
Your intro thread said: smooth tubes, a tune, & headers
With those boltons and a stock catback exhaust you are looking at <450 to the wheels
3"Headers going into a 2.5" stock cat then reduced down to 2.25" stock piping and muffler.
Yea... Thats not ideal
I would install a 3"hi-flow...
It really depends on the overall setup?
Are you still running stock headers and cats?
If yes, then def do yourself a favor and remove those rear...
A couple Q's:
Where are you located?
What is your driving experience & history of cars?
One of my friends is 6'-9" and his head...
No-one is gonna disable the revlimiter so dont scare him with that.
Also, no need to drive to test out the rev limiter. Just sit in your...
On my 97 (which has a slightly different T56) I am able to rotate and pull the shaft in/out by hand.
Click to the left(1/2 gate),
Click right to...
There are a several ways a Viper can be lowered or raised:
1. Shorter Springs (eibach) (1")
2. Thinner top spring perch 'Cap' (0.5")
SCT is the way to go so you can change between different tunes via flash controler and go back to stock tune at will.
For most tunes to be done...
Have you owned the Viper for several years and its just starting to do this now?
or is this your first winter with this Viper?
ahhh, I see you posted as I was typing a response :-)
Yes, 3-fin's... You have the good one. :2tu: