Search results

  1. R

    Replacement soft top installation

    OK, found the sliding clips underneath. I must say the the thumb screws seemed easier. But can anyone tell me what year is this soft top ?
  2. R

    Replacement soft top installation

    My original 1994 top was damaged while being transported. Insurance company paid to replace it. I purchased one from a company in Florida (Hot Cars ?) I just tried to install the top, but it's different than the original in that there are no thumb screws to hold the forward end of the side bars...
  3. R

    Help please

    I need a new or used soft top frame or complete roof for my '94
  4. R

    help needed

    I need a new or used soft top frame or complete roof
  5. R

    Gen 1 door Stanchion Covers

    Both sides are cracked with pieces falling off. Mr. Tator told me these are no longer available new. Does anyone have a source of aftermarket covers or maybe 3D printer replacements ?
  6. R

    Wheel & Tire package

    I've been out of the loop for a while. What is a good choice and source for a new set of wheels and tires for my car. 18's I guess, and wheels that will last a while without the blistering of the chrome plated aluminum wheels. All would have to be shipped to Hawaii, but I can handle the freight...
  7. R

    Battery

    Sears wants $154 for a 775 amp cold crank battery, any other recomendations ?
  8. R

    Great INJECTOR Service from Armour Racing

    Can anyone tell me how to contact Armour Racing ?
  9. R

    Stock Gen 1 exhaust pic's

    Re: Stock Gen 1 exhaust pic\'s Thanks guys, I think the right side must be stock, but mine is really rusted, I suspect that's why the left side was changed. But, the left side has a smaller diameter muffler and sure fits behind the rocker cover better. Thanks Again
  10. R

    Stock Gen 1 exhaust pic's

    Stock Gen 1 exhaust pic\'s I have just replaced my rockers covers and noticed that my left side cat/muffler set up is not the same as the right side. Does anyone have a picture of the stock set up for a 94 Gen 1 ? I searched the archives but only found pic's of modified systems. Thanks, Robert
  11. R

    These are fighting words!

    gotta be red, with stripes !
  12. R

    At 200mph YOU have NO Friends! -stickers are ready!!

    I'll take one of each. Check goes out in the morning mail. Thanks, Robert
  13. R

    Ahtifreeze on garage floor?

    I wish I could get me gen 1 to run that hot ! I replaced the radiator earlier this year and now it runs about 180-185. It may sound strange, but we do get some cold and wet nights here, and it would be nice to enjoy the heater once in a while. It was running up in the normal range with the...
  14. R

    Folding trunktop

    Any idea on what these sell for ?? Looks great !
  15. R

    Last Warranty Standing

    uh, it's either a typo on my end, or I've been had big time again....... :o
  16. R

    Last Warranty Standing

    My '94 has Chrysler coverage until 5/10/96. :cool: :cool:
  17. R

    Running Too Cool ??

    I just had a new radiator installed on my car. It seems to be running a little cooler as might be expected. The other night I was coming back from the other side of the island and up-country it started getting kinda chilly. I turned on the heater, but could not get any heat. I was able to detect...
  18. R

    Voltage between coolant and ground... bad?

    Whew, you guys.....anybody that has worked with automobiles long enough has run into Buick and Ford engines that have eroded aluminum timing chain covers or intake manifolds. This was when most if not all domestic engines were made of cast iron and alternators or generators were producing...
  19. R

    Where's the best place to take a leak ?

    Where\'s the best place to take a leak ? Does anyone know if the radiator is covered under the Chrysler extended warranty ? It's not damaged, just rotting away and starting to leak. If not, what are the options for replacing it with a new one ? Thanks
  20. R

    Harbor Freight Aluminum Racing Jack

    I got mine working. Had to add more hydrolic fluid, then pump it a bunch. But it works fine now.
  21. R

    Harbor Freight Aluminum Racing Jack

    They can't all be bad, can they ? What about you guys that already have them, did any of you have the same problem ?
  22. R

    Harbor Freight Aluminum Racing Jack

    Just got my new jack today, but I guess I have not been able to purge all the air out of it, so it does not work. Can anyone tell me the secret ? Harbor Freight can't. One tech says to use the vented plug, next guy says to use the solid plug, but nothing seems to make any difference. Thanks
  23. R

    Gen 1 VS Gen 2 - Where does the extra 50 horsepower come from?

    I was able to add the extra ponies to my '94, by using stripes from a Gen II car. They fit perfectly with out modification, unlike so many other upgrades. :cool:
  24. R

    habor frieght tools low profile jacks!! $99.00 right now! Wow!

    Re: habor frieght tools low profile jacks!! $129.00 right now! Wow! I just called and ordered one for myself. However, I was also told that they are out of stock on these. They said they would start shipping them in February, but will honor the $99 price if you order now.
  25. R

    How late into the season do you all drive???

    Usually put the Viper away as soon as the first snow hits. :headbang:

Latest posts

Staff online

Members online

Total: 910 (members: 8, guests: 902)

Forum statistics

Threads
153,198
Posts
1,681,911
Members
17,696
Latest member
Viper123456

Share this page

Top