Guys, after a brief warm up this morning I shutt it dn. I went to start it up again and got nothing.
Even after closing the doors the door locks don't even work. Battery had 13 volts, took it out and had it checked.
It was good, but I went ahead and got a new one anyways since it was 3 year...
Looking at this on Ebay:
http://www.ebay.com/itm/OEM-VIPER-SHIFT-KNOB-MINT-NO-WEAR-NO-SCRATCHES-03-04-05-06-08-SRT-10-GTS-DODGE-/271339250636
Can I replace my pistol grip shift knob on my 97 GTS with one from 03-06?, or does it need to be a 99-02 knob?
thanks!
http://www.youtube.com/watch?feature=player_embedded&v=XWjAKyAPhi8" target="_blank">http://www.youtube.com/watch?feature=player_embedded&v=XWjAKyAPhi8</a>"][/URL]http://www.youtube.com/watch?feature=player_embedded&v=XWjAKyAPhi8
Weak!
Notice it hits the rev limit on 4th at 140 mph.
This is d trim panel around the shifter and radio, same for 96 and 97. Let me know if u have one and what you want for it.
Contact:
[email protected]
Thanks.
Used in good condition, no 1/4 mile or burn outs. Around 1200 street miles.
$265 Shipped!
[email protected]
txt or call, 305-484-1047
thanks for looking.
Looking for (2) 345-35-18 A6s in good used condition.
I know some of you guys put a couple of heat cycles on them, and take them off.
Email me couple of pics and cost of what you got.
[email protected]
thanks!!
Guys, those of you who have done the install ( I've had Gen III seats on my GTS for a couple of yrs.)
Have you been able to install the Driver seat such that the center line of the steering wheel lines up perfectly with the center line (middle) of the seat??
I just noticed mine does not line...
I want to do 19s, but will use 26.8" tall tires in the rear and the 275-35-19 Front tires which are 26.6" tall, instead of the 275/30, or 285/30-19 which are 1" shorter(25.6/25.8).
Basically the same overall diameter of the 20F/20R Nitto Invo set up most run on 20s but on 19s, which have more...
I got HREs 545Rs now with the MTs Drag Radials in the back. Considering going 19s with road racing tires all around.
I'm a little undecided about the two choices listed above.
I would go full polished in 19" all around.
What do you guys think?
thanks!
Car with HREs 545rs in 18 (old pic)
CCWs...
Guys, I’ve notice the following kind of strange behavior of my coolant temps.
I’m cruising in stop and go traffic for 20-30 minutes or so, and the temps are fine. 192-197 deg.(TT car with front mount intercooler)
I have a AEM with the AEM pro gage, so I can read the temps digitally and also I...
Guys, A/C was working fine and blowing air thru the front vents. After a high boost pull it started blowing the air thru the vents in the rear of the dash by the bottom of the front winshield (defronst)
No matter in what position I put the switch in the console it blows the air in the same...
What a long road it has been with the tuning chapter of this car. I can finally say that my goal has been achieved and the responsible person that has made this happen has been Michael Brito from Brito Speed.:D
http://www.britospeed.com/
After being around for a while I have gotten to know most...
Found some vinyl paint to touch up my black dash around the speedometer. The color matches, but the base of the vinyl paint is enamel.
Whenever the enamel comes in contact with the stock paint it acts as a paint remover, and the stock paints peels off more.
Needles to say, what started out as...
I do a few 60-160 pulls on empty roads once in a while..
Recently changed tires height ,removed the Eibachs and put the lowering caps.
I would like to get an alingment done on the car as I'm sure the suspension geometry has changed some.
What do you recommend for street driving with good...
Guys, does anybody know the part number for the Spark plug wires heat shields?
These are the metal cylindrical tubes that go around the park plugs to protect the wires boot. They are attached to the cylinder heads.
TIA.!
JC
Guys, I'm thinking in doing the Vinyl stripes on my Red 97 GTS.
Undecided between Silver or White.
Is there any place in So. florida (Dade County-Broward County) that can do this?
What should I expect to pay?
Thanks!
When you remove the ECM cover to access the ECM you see the three big plugs that go into the computer.
Each of those plugs have a black "plug cover" that covers the actual wires going into the pins.
The little black covers is what I need.
Does anybody know wher I can get these? Is there even a...
The under carriage of my car is very clean. This past weekend I fired up the car in the garage and let it iddle for 15 minutes or so, and then shutt it off.
Next morning I see a spot of oil under the car right in the middle of the pan. After messing around with a mirror for a while, I pulled the...
I went this weekend to tune my car at Brito Speed.
BritoSpeed - Need Has Nothing To Do With It - Products
What an incredible place. The owner, Michael Brito, is a very knowledgeable tuner in both AEM and SCT.
The facility he has is incredible. Lots of cool machinery, and projects. He has a load...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.