Search results

  1. Z

    Anyone ever caught running no cats?

    Been running no cats for years. It's loud and no questions so far when it had to go to emissions. Love that I don't burn any bodyparts on the side sills anymore :)
  2. Z

    Throw up pics of your Personalized Viper License Plates

    http:// and the 'XS' doesn't stand for Extra Small, LOL!
  3. Z

    Personalized Plate

    Mine was [XS TORQ] but looking for new ideas. The best was seeing this roll through a Ferrari Club meeting :rolaugh:
  4. Z

    plugs and wires

    Yup, I had to replace my wires after a few summers due to the heat my SVSi headers generated and I have them wrapped. I know about the blower vent box also :(
  5. Z

    Won't idle all of a sudden

    Finally had the time to check things out with a buddy that knows more about the electrical side than me. Tested the TPS, MAP, IAC, plugs, plug wires, coils, and everything checked out fine. Started to check the PCM wires and only then realized the VEC1 was still connected and tapped in :omg:. I...
  6. Z

    Won't idle all of a sudden

    Had time to look at the car again and from the manual code P1296 says (No 5 volts to MAP sensor) - loss of 5 volt feed to MAP sensor has been detected. So I replaced the MAP sensor but still no luck. I'm a newbie when it comes to using my multimeter but I was able to test the connector and it...
  7. Z

    Won't idle all of a sudden

    I pulled the codes again after resetting the PCM by grounding the positive cable and the P1296 is the only code that pops up. I'll replace these next but was was your car doing when your sensor went bad? Was it not idling? Don't think it would cause the cutting out above 3000rpms, would it...
  8. Z

    Won't idle all of a sudden

    I just went to Advanced Auto for the CAM sensor, should I swap it out for a OEM? The CEL is still on so I'll see what codes are still there this weekend. Thanks for all the help. This is my first crack at trying to debug an issue and really new to everything. I'll try to do the most I can...
  9. Z

    Won't idle all of a sudden

    Installed the cam sensor but still shutting down at around 3500rpms. Still won't idle on it's own but seems a little better. Wonder if I need to drive it some so it relearns after I reset the PCM?
  10. Z

    Lifting Hood After Driving Due To Heat

    Have the Roe fan kit and just pop the hood in the garage after a drive. I think I have the Roe set to run for 5 minutes. If it kicks on I then need to keep the garage door open :D
  11. Z

    Won't idle all of a sudden

    Pulled two codes. Looks like 99 RT/10 was correct in guessing it's a cam sensor issue. Not sure on the other code if it's something that needs to be addressed. Will try to install this sometime during the week so it's ready for next weekend. Hopefully this does it :) Where and how is the best...
  12. Z

    Won't idle all of a sudden

    I just stuck the new TPS on without any adjustments. How do you adjust it? I'll try to get the codes off the car this weekend and also clean the IAC again.
  13. Z

    Chicago Motor Cars.

    I live about 15 minutes from there and stop in all the time to look at what they have. I know of several people that have purchased from them.
  14. Z

    Won't idle all of a sudden

    I disconnnected the battery to reset the PCM and now the car won't idle again :confused: If I ease on the throttle to bring up the revs everytyhing seems smooth until it hits 3500 rpms and it starts to cut in and out and the revs start to bounce. Like it's hitting the reve limiter at 3500 rpms
  15. Z

    Won't idle all of a sudden

    Put in a new TPS and now it doesn't die :) but idles very high or at whatever rpm I bring it too. I'm going to do the PCM reset and do what JPL suggests and see what happens.
  16. Z

    Won't idle all of a sudden

    I replaced the battery last week and the only thing that seemed to have changed is now when I blip the gas it will idle high for a few seconds before it dies unless I keep blipping the gas.
  17. Z

    Won't idle all of a sudden

    Thanks for all the suggestions. My car is a '99 RT/10 with headers, rockers, and no cats. I did replace the battery and cleaned the IAC best I could (wiped the pintle clean) along with the passage. Cleaned the TPS and IAC connections and made sure all the plugs and wires were secure. Cleaned...
  18. Z

    Won't idle all of a sudden

    Car was running fine the last time I drove it but went to start it the other day and it wouldn't idle. It fires right up but if I don't continue to blip the throttle it dies immediately. Replaced the battery and it now idles high for a few seconds then dies out. Took it around the block...
  19. Z

    Post up the best pic of your GTS/RT-10's

  20. Z

    GEN II aftermarket hard tops?

    Any pictures of the one piece from the front that you can share?
  21. Z

    TOOFST gets a new look

    Here's a few pics of TOOFST's new look for his RT/10. I think it looks good. With the sound of the heads/cam and now the black rims makes the car just plain sick!!! :2tu: Here's a close up.
  22. Z

    Anyone paint the stock GEN2 wheels BLACK?

    Do it TOOF :) Would like to see how they turn out. Bob...his shop is in Arlington Heights now.
  23. Z

    Best way to remove cats??

    Hey Mike, the best way would be to have TOOOF's guys do it, right TOOOF? :2tu:
  24. Z

    IL VC one lap this saturday

    http://onelapofamerica.com/history/2006/results/showResults.shtml?y=2006&res=OVL_CUM Good Luck Ron!!!
  25. Z

    DO NOT MISS SEEING THIS CAR! LOOK HERE!!

    I believe Ron has won the 'One Lap' a few times in the past with some awesome cars he's put together. Good Luck Ron!

Latest posts

Members online

Total: 515 (members: 3, guests: 512)

Forum statistics

Threads
153,191
Posts
1,681,858
Members
17,686
Latest member
Javadog62

Share this page

Top