Search results

  1. O

    Bigger Rear

    Does anyone make a bigger caliper for the rear that works with the stock 13 rims? I know about Toms 42mm caliper but what else is there? I took a drive hitting the brakes alot. The fronts were nice and hot but the back claipers were barely warm...obviously they arent doing any work and I removed...
  2. O

    Always Hard.....

    No this is not a thread about Viagra :) I have a brake problem. I have recently updated pads to HPC street Hawks and new rotors drilled and slotted. I bed the pads but the brakes still do not feel right. One issue is that I dont know how they are supposed to feel. How much travel should be in...
  3. O

    Brake Improvements

    I just finished installing a supercharger on my Gen 1 (1995) and now the stock brakes ae really scary :) I have stock 17 " wheels and stock brake components. This is for the street only but with the stock setup I feel like I am not going to stop. I know about Toms 40mm rear brake kit but I think...
  4. O

    Removing tranny

    I am in process of replacing leaking clutch slave in my 1995. I have all 8 bolts off from the tranny to bell housing and a jack under the oil pan and tranny jack under the tranny. I can not get the tranny to "slide out". If I wiggle the tranny from the drive shaft end, the whole engine wiggles...
  5. O

    Where to buy rubber boot

    Replacing my clutch slave on my 1995 and I found that my rubber shift boot/seal underneath the center console is torn up. Anyone know where I can pick up a new one? Tx all
  6. O

    Fluid from my Tranny

    My 1995 with 68K just developed a leak coming from the center of the bell housing. Its from the hydraulic clutch. I checked where the line from the clutch master goes into the tranny case and its dry there. Is there a magic solution here or is this remove the tranny and replace something?
  7. O

    Ignition Wire Fit

    I bought a new set of ignition wires for my 1995 Gen 1. They are Mopar p5007309. I started installing them but the lengths are wrong on some of the wires. Are Gen 1 wires different then Gen 2..its the same engine??
  8. O

    What belt for Paxton

    My 1995 has a Novi Paxon on it. Does anyone with similar install know the part number for the serp belt for the supercharger?
  9. O

    Looking for supercharger

    Looking for low mileage super charger system for Gen 1 1995
  10. O

    WTB supercharger system

    Looking for low mileage super charger system for Gen 1 1995
  11. O

    Chrome Valve Covers

    Looking for Chrome Valve Covers that will fit Gen1.
  12. O

    Valve Covers

    Does anyone know where I can find chrome valve covers for my Gen 1??
  13. O

    Fan upgrade

    Has anyone put the radiator fan from a 1999 to 03 on their Gen 1? Is it a real improvement in cooling or not much of a difference worth the $?
  14. O

    brake pads for the rear

    Whats a good brand of brake pads to use on the rear to give them more bite....I dont care about brake dust on the rear. I understand this can help offset the brake balance issue on the Gen1's.
  15. O

    Roller Rockers

    I have done some searches on this but still have a few questions. I am planning on going with the Harland Sharp 1.7 ratio rollers on my 1995. I want to also change to high strength push rods. If the engine is stock, what length rods do I need? Also, this may be a stupid question but my...
  16. O

    Why would anyone do this?

    I have a new to me 1995 RT10 with 60K miles. I have had an issue that I posted earlier about rough idle which I got some great ideas from forum members but everything checked out. One major symptom was that it idled rough only after it warmed up. Yesterday I was under the car and noticed that...
  17. O

    Mail order rear ends?

    Is there any good places that I can remove my 3.07 rear and send it away to have it converted to 3.55? I live in Maryland and have not found anyone close to drive the whole car there for the conversion.
  18. O

    Looking to trade 3.07 rear

    I have a 3.07 rear from my 1995 rt10 that I am looking to trade with someone that has a 3.55?
  19. O

    Rough Idle

    I have a new to me 1995 with 60K miles. She runs great but it idles "rougher" than I would think it should. I have done all of the normal "tuneup" stuff and it runs great thru the rpms. Looking at the engine from the outside it looks like its idling smooth but sitting in the car it shakes quite...
  20. O

    Viper Shop in Maryland

    I recently bought a 1995 and I want to change the stock rear gear from 3.07 to 3.55. Does anyone know a shop in Mayland that they would trust their "baby" with to do this work? I assume a Dodge dealer would be lots of $?

Latest posts

Members online

Total: 696 (members: 8, guests: 688)

Forum statistics

Threads
153,190
Posts
1,681,853
Members
17,685
Latest member
Lennatave

Share this page

Top