Okay guys... I am probably walking a line right now that doesn't appear to be widely accepted. I'm researching suspension, and in my past vehicles air ride was always what we went to. Adjustable heights, being able to drop low for fun, and raise it for clearance. The current issue is that I want...
Hey Guys,
I have not seen this mentioned and I searched for it. For an 08 SRT10 Vert, I want to bypass the clutch. Where under the hood are the wires needed to do this. If anyone has the wiring schematics for this I'd appreciate it. I have done this on every vehicle I own, I hate having to get...
Ok Guru's. You guys know a hell of a lot more than I do. I want more power and I refuse to get passed by a GTR on the highway again. I have been looking at nitrous and weighing the pros/cons. I have read a LOT over the last couple weeks. I have a pretty good general idea on how to make it safe...
Hey Guys, Looking for some info. If anyone who has a Gen 4 with the Mopar ECU, and has a data logger, I am trying to find out how much (if any) the timing was advanced on the upgrade "race" ECU compared to the stock ECU. The use of 93oct Fuel has me assuming that it's advanced a small amount...
I have seen this so many times now, and I am trying to figure it out. I have a hard time with understanding how guys can have these cars with 800 miles, or under 10,000 miles on cars that are over 5 to 20 years old. Is it just something that sits in the garage to show people? Are you scared of...
I searched and didn't see anything for the Gen 4. Does the Gen 3 pulley fit the Gen 4? Is there a reason not to do this for the Gen 4?
Thank you gents'
Getnlwr
Guys, I am having a issue with my 08 vert. The passenger door is rubbing in the front of the door where it meets a triangular panel. The panel appears to be inboard a small amount at the top and just need to be adjusted outboard. the door appears to be aligned correctly with good spacing...
I have not had my Gen4 all that long, and I want to switch out the shifter. I am not satisfied with what is available. I have access to a lathe, however It would be helpful if someone knows what the stock thread pattern is for the base of it. It will end up as a billet shaft that is same specs...
I just picked up a 2008 Convertible. I traded in my 2006 SRT ram to get her. All I can say is she's absolutly gorgious as a topless ride!
Looking for power and performance upgrades. I was told recently that Torrie was working on cracking the ECU, and that there may be something relativity...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.