1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Block refresh near KC

Discussion in 'General Viper Discussion' started by MoparMap, Jul 10, 2019.

  1. MoparMap

    MoparMap VCA National President

    Posts:
    1,540
    Joined:
    Jan 7, 2013
    Location:
    Kansas
    So I recently spun a pair of rod bearings on my car during a track day and am working on rebuilding the engine. I've got it out of the car and all torn apart and it looks like I only have the one roughed up crank rod journal. That being said, while I've got everything apart I was going to clean up the block and replace standard wear parts while I'm at it. I'm wondering if anyone knows a place around the KC area that might have a torque plate for a Viper engine. Any local shop can hot tank the engine to clean it up, but if the bores need any work it would be nice to not have to run a block around to multiple shops looking for one with the right tools. Not sure if I'm going to need anything more than a deglaze, but if the cylinders don't measure out good then it would be nice to be able to get it bored/honed while I'm there.
     

Share This Page