Gen IV heads and intake.

Discussion in 'Vendor Review: DC Performance' started by Boxer12, Feb 18, 2011.

  1. Boxer12

    Boxer12 Viper Owner

    Posts:
    2,618
    Joined:
    Jan 6, 2006
    Location:
    Colorado High Country
    I have just installed the DCP Gen IV heads and intake. Great product, they were received in a timely manner in flawless condition. Very nice work. A few questions during install, and the DCP tech support was as expected...great. I have over 5000 track miles on the car, and the power is definately improved....SWEET! I can't wait to get the car out on the track and see the improvement in MPH and lap times. Thanks Dan. :2tu:
     
    Last edited: Feb 19, 2011
  2. Boxer12

    Boxer12 Viper Owner

    Posts:
    2,618
    Joined:
    Jan 6, 2006
    Location:
    Colorado High Country
    Just got on the dyno (Dynojet 248) and pulled a 605 RWHP (first run) on 91 Octane gas with no additives. SWEET! Power delivered! Thanks again Dan!!!
     
  3. Dan Cragin

    Dan Cragin Enthusiast

    Posts:
    1,203
    Joined:
    Feb 16, 2007
    Location:
    LA, CA
    Thanks Jim,

    We at DC Performance worked very hard to produce a head and manifold package that would produce proven results. There was quite a bit of skepticism about our product, but time and time again we are seeing over 600rwhp results.

    Big thanks go to our engine performance consultant Lyle Larson for his development on this.

    Stay tuned for some new G4 power adders.
     

Share This Page