Recent content by luketrot

  1. L

    Anyone replace their clutch master cylinder in their gen3?

    Just looked at the book. Looks like the fender needs to come off. Seems like a real pita. Also how hard is it to get the pin out? Does the replacement come with one?
  2. L

    Foot caught clutch pedal and pulledit back too far!

    Re: Foot caught clutch pedal and pulled it back too far! Looks like the spring should pop back in place but I wasn't successful working on the floor. I suspect the clutch master Cylinder will need to be removed. Any guides online on how to remove it? Anyone else have this issue of the clip...
  3. L

    Foot caught clutch pedal and pulledit back too far!

    Getting out of my Gen 3 viper my foot caught the back of the clutch pedal and pulled it back too far. It appears to have separated the clutches master cylinder. There is a c clip that popped out and fluid leaking. The clutch pedal now wants to rest much further back then it should. Any...
  4. L

    Just bought a VIPER!!!

    Bendpak is decent, first lift so I don't have much to compare it too. Just had the high door tracks installed last week so I haven't used it for car storage yet. I would highly recommend the RJ45 rolling bridge jack accessory if you plan on doing any work on your cars. Google Bendpak RJ45 if...
  5. L

    Just bought a VIPER!!!

    Just a normal C6, not Z06 in the background. The Bendpak lift was installed a few months ago. I bought the car from a member of the Viper Club on this forum so it may look familiar to some. Location is Maine.
  6. L

    Just bought a VIPER!!!

    Very excited about my latest car purchase. 04' SRT-10 Viper with 6800 miles. Much more comfortable then I expected.
Top