Recent content by Visker
-
V
Paxton tensioner question.
Has anyone seen this tensioner on a paxton setup before? I am in the process of rebuilding a paxton charged 98 GTS , I was not building any boost so I decided to check the belt tension on the blower. I find this tensioner that keeps pushing the tensioner pulley crooked, blower makes alot of...- Visker
- Thread
- Replies: 2
- Forum: RT/10 and GTS Discussions
-
V
Is there a market for stock Gen II heads?
Wish you woulda said something sooner, I just paid 1200 bucks for mine.- Visker
- Post #3
- Forum: RT/10 and GTS Discussions
-
V
GTS Powertrain management troubles.
Having some trouble with a 1998 GTS, Several DTCs stored, an entire list acctually. While driving the car will randomly start running rough, check engine light will start flashing very fast, no ryme or reason or consistancy, except one day it did it every 60 seconds on the nose, just one day...- Visker
- Thread
- Replies: 0
- Forum: RT/10 and GTS Discussions
-
V
Hood hinge installation.
These hood hinges on my 98 GTS are driving me nuts, after hours of searching I still can't figure out how to install them? Any help? Thanks.- Visker
- Thread
- Replies: 4
- Forum: RT/10 and GTS Discussions
-
V
Exhaust opinions??
lol, no cats, liking the race bullets, cheap if i decide to go another route. See if I can find a sound clip?- Visker
- Post #7
- Forum: RT/10 and GTS Discussions
-
V
Exhaust opinions??
This is what I am working with, edlebrock headers into custom exhaust all the way back near axles and cut off. I was thinking of tossing in a couple mufflers, need something that flows extreamly well but sounds good. Any opinions?- Visker
- Thread
- Replies: 12
- Forum: RT/10 and GTS Discussions
-
V
Does anyone make a driveshaft loop for our cars , or are they unnecessary? ---
Honestly, not sure what happend? Thats how I purchased the car. It has a paxton with some fueling and head upgrades, will have to get some dyno numbers when she is back on the road. Just bought a driveshaft, already have it in, need to replace transmission mount, I think trans mount gave out and...- Visker
- Post #13
- Forum: RT/10 and GTS Discussions
-
V
Car keeps popping the pass side headlight fuse, low beam (HID conversion)
Hey, just checking in? how is the headlight situation? Have some illistrations that may help the situation. That splice may be a long shot with a viper, probably doesn't sit outside in the rain and snow, but its worth checking.- Visker
- Post #7
- Forum: RT/10 and GTS Discussions
-
V
Car keeps popping the pass side headlight fuse, low beam (HID conversion)
If your blowing just the passenger side headlamp, I am assuming it is going to be fuse 10, 10amp in the PDC??? Correct me if Iam mistaken, that circuit is going to have two possible locations for your short to ground if you have already ruled out the HID ballast. It will be in the wiring, (fuse...- Visker
- Post #4
- Forum: RT/10 and GTS Discussions
