The biggest problem that I have is when I am working with the wiring section. When using the manual, I usually have multiple pages to be open at the same time and with a CD that is hard to do. So then I end up printing all of the pages that I need. A CD stores better than a book but you need to...
In the Spring 2001 issue on page 34, Hal is commenting on the torque specs for the ring gear bolts. He indicated that the spec should be 80 +/- 10 foot lbs, but it ended up in the quarterly indicating 8 +/- 10 foot lbs.
Go to the Section 8 of the Service Manual and find the Fuel/Ignition System wiring schematic. I don't know what year vehicle you have, other wise I would tell you what page to look at. All the injectors have a Dark Green w/Orange tracer wire attached to them. This is the 12 volt feed. The other...
Yes, but I need to know if you are checking the voltage by back probing the connector or you are checking the open circuit voltage with the connector disconnected. The voltage on the green wire with the key on only, will give you a baro read or in other words the altitude you are at. But not...
Hummmm, this could be a two part answer based on the VIN of your vehicle. As a running change in 1993 (VIN 605) the reverse lockout was changed from a spring loaded detent, to a PCM controlled lockout solenoid. When the key is turned ON and vehicle speed is 3 mph or less, the PCM will energize...
Just heard from Tommy Archer that they will run a 2001 Viper in the Trans-Am next year. Car will be modified to meet the requirements and keep an even playing field. Engine is to be a Caldwell V-8 with a lot of horsepower.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.