Search results
-
M
Failed windshield wiper motor?
Took the Viper ('96 RT/10) out the other day to warm it up as it has been sitting for almost two months and it started to rain. When I turned on the wipers the passenger side went slower and appeared to be struggling. This caused them to get out of time and the blades got tangled. Has anyone...- Mark Hahn
- Thread
- Replies: 25
- Forum: RT/10 and GTS Discussions
-
M
Harland Sharp Rocker install
Just got around to measuring one cylinder's pushrods in preparation for my Harland Sharp rocker install (Intake & Exhaust). It looks like I need about 7.3"~7.4" pushrods for my '96 RT/10. Does this seem shorter than normal. The stock rockers pulled out of that cylinder were slightly under...- Mark Hahn
- Thread
- Replies: 3
- Forum: RT/10 and GTS Discussions
-
M
PCM in a '96 RT/10?
PCM in a \'96 RT/10? Wondering if anyone knows what type of PCM is in my '96 RT/10. Some of the car is Gen II (suspension, exhaust-rear exit) and some is Gen I. Dodge lists the car as 415bhp which is more than GenI but less than Gen II (450) but the Tourqe as the same as Gen II (488~490). My...- Mark Hahn
- Thread
- Replies: 0
- Forum: RT/10 and GTS Discussions
-
M
Pushrod length checker Recommendation?
Anyone have a recommendation on a good pushrod length checker for our cars? A Gen II if there is a difference. Thanks, MGH- Mark Hahn
- Thread
- Replies: 7
- Forum: RT/10 and GTS Discussions
-
M
Installed New Headers
Just installed a new set of Hooker headers on my '96 RT/10. They are ceramic coated so will be a little cooler than stock. I have Magnecor wires and was wondering if most people remove the little heat shield tubes from their plugs? When istalling headers, do most leave off the heat reflective...- Mark Hahn
- Thread
- Replies: 6
- Forum: RT/10 and GTS Discussions
-
M
Coputer upgrades
I hear a lot about the Vec 1 or Vec 2. Has anyone tried West Coast Vipers PCM upgrades or JET performance computer upgrades (send in your PCM)?- Mark Hahn
- Thread
- Replies: 1
- Forum: RT/10 and GTS Discussions
-
M
Gen 1 vs. Gen 2 fuel injectors
Anyone know what the difference is between Gen 1 vs. Gen 2 fuel injectors? Is there any performance gain. What if the exhuast/intake are upgraded in a Gen 1 engine? Thanks, MGH- Mark Hahn
- Thread
- Replies: 1
- Forum: RT/10 and GTS Discussions
