Anyone used these headgaskets?

[carl B]

SCE Pro-Copper Head Gaskets
.8128mm 90933 $106.42
1.0922mm 90934 $106.42
1.27mm 90935 $115.91
1.5748mm 90936 $122.36
2.032mm 90938 $130.58
2.3622mm 90939 $141.29

I saw these advertised and wonderd if anyone had used them instead of the factory gaskets?


Carl

 

[1TONY1]

Copper gaskets will work best if you have the block o-ringed and a reciever groove in the head......then you have to worry about water seeping out from between the head and block. I'm not sure if they would recommend running them without o-rings.
Save the trouble unless you are going to be running very large
amounts of boost.

 

[MaxedGTS]

the gaskets have been proven to work on the DLM motor in the Heffner car that just ran fast as sh*t. i woudn't want to use them on a daily street car but if you take the extra precautions you probably make them seal up. Had them on my gen 1 no problem.
Max

 

[Joseph Dell]

I second what Tony said. Except that my car is a street car and I drive it all the time. And, the best part, is that copper gaskets are re-usable!

JD