grrrrrrrr code p0340 wont start

[tmr4479]

Car wont crank when hot. Ive already installed new cam and crank sensors about a year ago. Anything else I should look for, or just try new sensors? I did install a svs shifter and MGW knob today while its on my lift, seems to shift pretty nice. Only if I could get it started again to go drive it lol.

 

[Ulysses]

Inspect the connector pins and plug. Make sure that nothing is broken in the connector and that the pins are clean. If all looks well, inspect/test the wiring from connector to PCM. Could be anything from the sensor to the PCM.

 

[tmr4479]

ok ill try checking the plugs, the thing that gets me is it will start fine when its cold.

 

[Ulysses]

Expansion/contraction of contact pins? PCM degradation such that electronics no longer function at hot? Could be, but a good diagnosis of the complete system will reveal.

 

[tmr4479]

got it running then i got the same code plus a p1391

 

[Ulysses]

intermittent cam or crank sensor signal.

 

[tmr4479]

well i just went ahead and ordered new cam and crank sensors and the engine harness