What happens if your bottom clips are not attached to your airbox?

[Early93Viper]

Went and did my K&N air filter change today to find out I have no bottom clips on my airbox. Do you think I was sucking dirty air into the engine? I hope not.

 

[STUGOTS]

I doubt you were sucking dirty air HOWEVER you WERE killing HP

 

[HOdbleFman]

You need to have a certified viper tech remove the heads and check the condition of the cylinder walls immediately.

 

[Early93Viper]

Seriously your kidding right?

 

[Qualitywires.com]

You need to have a certified viper tech remove the heads and check the condition of the cylinder walls immediately.

LOL! I about toppled over and died!


Hey if you PM me your address, I have a few clips I will mail out to you! The clips will fall off due to the engine movement and the airbox being a poor design...plus the clips are help on by a crappy hinge.

 

[Nadine UK GTS]

No worries! They clip right back in there!

Take Adam up on his most generous offer or get in touch with Chuck AKA Viper Wizard ([email protected]) he can supply them at a bargin price.

Your motor will be fine!

 

[RedEnuf93]

They are Chevy clips, part nr. 25043286
About 2 bucks or so per piece.

 

[Cris]

Just another Gen I/II deficiency.

 

[95Viper]

When you replace the clips, place them on a hard surface and hit them gently with a hammer to lengthen them just a tad.

 

[STUGOTS]

you can get new clips at www.roeracing.com for 2 bucks.