Have a set of cheap summit gears in a car running 8.60's with a 1.23 60ft.... I kinda have to say bullcrap on that. Been there for two seasons. Ring and pinion is ring pinion... not viper specific. Yes there are differences and price ranges, but I think he will be fine with that. Arnt you the...
I'm hooking it up... the tach signal wire doesn't cut it and that driver didn't work either. I called Aeromotive and they said this controller will not work properly on a viper without the MSD tach signal adapter. Said I should also run the signal booster because i will be running my pump...
thanks guys... I will look to verify that I have the correct wire. If I don't, i will correct it... if I do have the Tach signal wire, i will switch to a inj driver as J. Dell Suggested. the 20% off wouldn't pose a problem as the controller is adjustable. thanks
I hooked up the Aeromotive pump controller on my 95 as per the instructions. I pulled the tach signal from the upper PCM, Cavity 43 GY/LB. I started the car and the pump runs with none of the LEDs lit on the controller. When I hit the override switch, the green SWT light comes on. From what I...
I had purchased a catch can from JMB and it was better than expected. I'm about finished with my car and wanted to install that beautiful Cold air box and tubes on my 95 Roe with ****. It really looks like a clean install. Has anyone installed on Gen1?
I was looking at the "long" version...
A little background on my 1995 RT:
I pulled and freshened my motor with some new goodies and also installed a 10lb ROE. I retained my NX system so needed to upgrade my fuel system. I removed the stock fuel pump and sumped my factory fuel tank. Ran -10 to filter and A1000 fuel pump, up to a...
hi guys, my 95 rt10 was factory green and had been painted viper blue. will a 96 hood pad fit my car the same? :dunno: Looking at the hood pad from R and J that has the blue viper logo. thanks
:usa:
I called Diamond and they do have them. He told me years vary and didnt know if i needed the 1.5mm or 1/16" 1st and 2nd ring. Can anyone help? I broke my mic. I know 1/16 works to be 1.57mm and they are not the same set. thanks
Hi all,
Installing a ROE 10psi on my 95. Looking for piston rings as i pulled the motor and had the cylinders honed. Really didnt want to, but I was that far and they didnt look great. Did a search and didnt come up with much. I'm looking for brand and part numbers for good rings for my stock...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.