Hisserman
Enthusiast
Great lookin', Treesnake. 
functional adjustable splitter install question
- Thread starter davem
- Start date
davem
Enthusiast
Almost done
Well,
Here are a few updated pics. Splitter support is 1/4 aluminum bolted to the frame where there used to be some plastic spacers, then it reaches out 11" under inside the fascia. I use shims between the splitter and fascia to adjust the angle of attach. Drilled 4 holes in the bottom of the fasica, not too bad.
Pretty solid so far. Still need to trim the mold flash off the edges and clear coat it, but it's coming along.
-Dave
Well,
Here are a few updated pics. Splitter support is 1/4 aluminum bolted to the frame where there used to be some plastic spacers, then it reaches out 11" under inside the fascia. I use shims between the splitter and fascia to adjust the angle of attach. Drilled 4 holes in the bottom of the fasica, not too bad.
Pretty solid so far. Still need to trim the mold flash off the edges and clear coat it, but it's coming along.
-Dave
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
dave6666
Enthusiast
Great pics. Can you mail me a brochure with your full product lineup? 
BOTTLEFED
Enthusiast
That looks awesome!
I love the look of CF
this is exactly what I've been looking for - PLEEEAAASE make me one too
and those TTs are bada$$ sitting there up front
I love the look of CF
this is exactly what I've been looking for - PLEEEAAASE make me one too
and those TTs are bada$$ sitting there up front
