Just got around to measuring one cylinder's pushrods in preparation for my Harland Sharp rocker install (Intake & Exhaust). It looks like I need about 7.3"~7.4" pushrods for my '96 RT/10. Does this seem shorter than normal. The stock rockers pulled out of that cylinder were slightly under 7.5" by a few thousands. I will measure all cylinders first and per the Harland Sharp instructions I only had about 1 complete thread showing on the bottom when I started then turned them down to zero lash which was about 1 more complete turn and measured the adjustable pushrod. Does anyone know if Harland Sharp rockers tend to need a little on the short side for pushrods? Thanks, MGH