Help Rack & Pinion part

[Copperhead133]

Can use some help i'm In need of cross over tube on Rack & Pinion right side of rack to valve or the whole rack. They don't sell just the tube. 06 coupe

 

[Viper Parts of America]

Not quite sure what you are looking for - is it one of these parts?

If it isn't available by itself new, then try X2 Builders or Don Scharf Automotive for used.

 

[99 R/T 10]

Thats the rear end exploded view. I think he needs the steering rack, specifically one of the smaller tubes on it. I have a complete rack and pinion off a Gen II, but not sure if they used the same one thru 2006.

 

[Copperhead133]

Its for the Steering Rack, 2005 and up. Gen 2 and 03-04 Gen 3 is different

 

[Viper Parts of America]

*blush* We were working on gear sets last night and "pinion" triggered an auto response. This should be better:

 

[Copperhead133]

Yes that is it . The small tube in the middle is what i need.

 

[Viper Parts of America]

Yes that is it . The small tube in the middle is what i need.

#8 or no number on it? We can help either way, if nothing else to refer you to the right place.

 

[Paul Scharf]

I have the tube you need. IM me if you would like to purchase it.

 

[Viper Parts of America]

If it is #8, here you go:

https://www.viperpartsofamerica.com...iper-steering-gear-mounting-isolator-04642116

 

[Paul Scharf]

#8 in your drawing is a bushing for mounting the rack,
the OP is after the tube that goes from the left boot to the right boot on the rack housing,
You can not buy this part separate from the rack itself.
You have to buy a complete used / new rack and pinion assembly or find some one who has a damaged rack laying around
that is willing to sell one.....