Need 3rd Gen. Viper logo.

[2easy]

Hello Everyone,
Im looking for 3rd Gen. Viper logos for my brake calipers. I have taken on the project of painting my grey calipers (you know those ugly ones on all 03 verts) red and need the logo put back on in metalic silver. I have already ordered logos from Xenomods but am afraid I will receive the 1st or 2nd Gen. they display in their advertisment. I have sent several emails regarding this issue without a response. Anyone out there make them or know who does? HELP!

 

[Neil - UK]

pm sent, i can help

 

[georgethedog]

pm sent, i can help

Neil, same issue here. Could you share your information again. Thanks.

 

[2easy]

Thanks Neil, you my friend are a life saver...props to u!

 

[JohnnyViper]

i as well need logos for my soon to be painted calipers, if they send you the wrong ones and you can not return them my gen 2 would be happy taking them off your hands

 

[SNKEBIT]

I have a bunch. What do you need????

 

[Bird325]

I have a bunch. What do you need????

SNKEBIT, Do you have Sneaky Pete? I'd be able to make use of a logo file that's ready for engraving/embroidering.

 

[2easy]

Sure Johny Viper, Im sure we can arrange something. SNKBIT, Im looking for 4 inch metalic silver viper logos, 3rd generation.

 

[85 of 200]

PM me if you still need help with this.

 

[SNKEBIT]

SNKEBIT, Do you have Sneaky Pete? I'd be able to make use of a logo file that's ready for engraving/embroidering.

What format do you need?

 

[SNKEBIT]

Sure Johny Viper, Im sure we can arrange something. SNKBIT, Im looking for 4 inch metalic silver viper logos, 3rd generation.

I think I have them. let me know.

 

[labtec]

I ordered these for my 04. As I recall they were slightly shorter than the existing faded logos. Before removing the old logos I measured their location and made notes to help properly locate the new logos. I used steel wool and lightly wiped until the original logos were removed without damaging the red paint on the calipers. Using the previous measurements with a pencil and small piece of paper make a template to help average the location of the new slightly smaller logos. The wheels are the new 6 spoke type so I was able to install all four logos without removing the wheels. I must say the logos have been through many washings and still look brand new with no chipping or peeling. Also they sent me 6 instead of 4, spares are good....

 

[GTLaser]

Doing a BBK now and need some logos replaced, anyone have any extras or know where to find them? Thanks!