ViperBite
Viper Owner
I am doing the change out of the PS pulley and bracket. Bracket is on with no problems. I am doing it the "easy" way by not removing the pump.
I have gone to two auto stores and rented the pullers. Neither stores pulley halves will fit the groove in the plastic pulley. They are too wide for the groove in the plastic pulley. It is damn close but not close enough.
Ideas, thoughts or should I try yet a third store?
Also does anyone know the thread dia/pitch that is used to re-install the new pulley? Neither of the kits seemed to even thread into that bolt hole. I have looked to see if it is damaged but it looked ok.
Thanks.
I have gone to two auto stores and rented the pullers. Neither stores pulley halves will fit the groove in the plastic pulley. They are too wide for the groove in the plastic pulley. It is damn close but not close enough.
Ideas, thoughts or should I try yet a third store?
Also does anyone know the thread dia/pitch that is used to re-install the new pulley? Neither of the kits seemed to even thread into that bolt hole. I have looked to see if it is damaged but it looked ok.
Thanks.