Search results

  1. Steve-Indy

    Remote control GTS

    Test your email to me at 317-402-9013 and I will send it to you.
  2. Steve-Indy

    Remote control GTS

    If you have the correct remote, you can program up to 4 remotes to your 1997 Viper without using a scan tool. Full directions were posted on this site over 20 years ago by "Ron".
  3. Steve-Indy

    JTSV and Havik Still in business?

    I would suggest that original poster CALL Mike at 484 274 3037 I sent Mike a link to this thread.
  4. Steve-Indy

    power to fuel pump

    If it cranks over, not ASD 1 fuse. ASD relay may shut off both fuel and spark if PCM does not detect engine startup within 1-2 seconds as tech said. PCM needs to see signal from crank sensor, can sensor, MAP sensor, and upstream O2 sensor for start/run. Looking for CEL/codes may help...along...
  5. Steve-Indy

    power to fuel pump

    Have you checked ASD 1 fuse ? That fuse blows with some frequency on early G III's...and would also be associated with no starter action. Other causes of the scenario you describe have been loose ground straps. More info would help.
  6. Steve-Indy

    Oil Filter Recommendations

    No, not at all Bill. The filter that you referenced is the same concept but it will only fit Gen Iv and V Vipers. The special, similar concept filter for for Gen I, II. and Gen III Vipers is part number 05037836AB. NEVER use the earliest form of this Gen I, II, III filter marked 05037836AA
  7. Steve-Indy

    Oil Filter Recommendations

    Bill, here is a post from the "SRT Engineers" on this Forum: "The SRT oil filter for all the past engines and the new 22mm inlet SRT filter for the Gen 4 and beyond engines share the same characteristics. We worked with many of the filter suppliers to get the best features. Some fell out for...
  8. Steve-Indy

    Question about coolant change on my 1997 GTS with 16k miles

    Congrats !! I would suggest that you pick up a 1997 Viper Service Manual online...cheap. In my experience, clutch fluid, diff fluid, and tyranny fluid often get neglected...along with coolant. You might gradually work your way into changing these in the near future. Since many of "factory...
  9. Steve-Indy

    Was there an AAR edition Viper?

    OR...did original poster mean "ACR" ?? If the answer is "yes..ACR", there ACR's were made by Dodge 99-02, 08-10, and 16-17.
  10. Steve-Indy

    Gen2 GTS hood alarm switch location?

    Sent.
  11. Steve-Indy

    Gen2 GTS hood alarm switch location?

    John, text me st 317-402-9013 and I will a pic to you from our 01.
  12. Steve-Indy

    Gen 2 Replacement Battery

    Odyssey is a great battery in my opinion. I did not list it because I have not tried tobinstall a group 78 in a Gen I or II where it could be a tight fit. I do have the Odyssey Group 34 in 3 other Vipers and they are all still going strong at over 14 and 16 years later. By the way, when you...
  13. Steve-Indy

    Gen 2 Replacement Battery

    My preference for our Vipers (5) where the battery resides behind the left rear wheel, I have moved to Interstate groups MTZ series. These are AGM batteries and outlast the flooded lead acid batteries by a factor of 2-3 times...and, they carry a 4 year fully refundable warranty after which...
  14. Steve-Indy

    Help needed / Wiring Diagram for 1998 Viper GTS Map Sensor / P1296

    Motormax, if you want, text your email address to me at 317-402-9013 and I will send to you the pinouts of the three connectors to the PCM (Powertrain Control Module) as shown in the 1998 Viper Service Manual.
  15. Steve-Indy

    Help me please. I need a wiring diagram for my ecu

    Resent via email
  16. Steve-Indy

    Help me please. I need a wiring diagram for my ecu

    Good to speak with you, Sir !! If you did not get the diagrams, etc, just text your email to me and I will resend them to you using that method.
  17. Steve-Indy

    Help me please. I need a wiring diagram for my ecu

    Sorry for your difficulties. We need to know the Generation of Viper since many systems evolved with time...including "ECU" and alarm/anti-theft systems. Before your tech tears into the wiring, you may want to look up the alarm system function for your year on this forum...since part starting...
  18. Steve-Indy

    How to search engine history via VIN

    Always around !!
  19. Steve-Indy

    How to search engine history via VIN

    Viper Jeff is the Man !! Jeff_ATX, there may be one more beneficial source to explore...unless, you have decided to drop the issue.
  20. Steve-Indy

    How to search engine history via VIN

    Understood !! That phone is on from 6 AM til 9 PM daily.
  21. Steve-Indy

    How to search engine history via VIN

    Jeff, my number is 317-402-9013 Sorry, I forgot to post it due to an incoming phone call.
  22. Steve-Indy

    How to search engine history via VIN

    Hi, Jeff...interesting "situation". I notice that you are using the last 8 digits of the VAN's in your post. Do you have the full VIN for the Viper from which your motor came? If not, I have a suggestion for you that MIGHT lead you into more historical info. Feel free to contact me. Steve
  23. Steve-Indy

    New BCM Repair Services

    Excellent post, Dan. Thank you, Sir !!
  24. Steve-Indy

    Help with Gen V Service Manual

    By the way, Steve...if you are "up a tree" on something relatively simple, tell me the year, I can fire up that old Vista, and take a screen shot for you. Just a thought.
  25. Steve-Indy

    Help with Gen V Service Manual

    Hi, Steve: I know IE can be found made functional...try this (though I have not had to yet)...

Latest posts

Members online

Total: 1,282 (members: 5, guests: 1,277)

Forum statistics

Threads
154,528
Posts
1,691,590
Members
19,290
Latest member
CfloGTS

Share this page

Top