I didn't see anything about the side sill metal screws falling out and getting stuck in the rear tires, at least in my 97 GTS. I did a write up back then to replace the screws with machine screws and and to place insert nuts into the frame. That was a big problem back then and still is if the...
I have the original owner's manual that was in my 97 GTS when new. It is even wrapped in the original plastic. When I bought the car, neither I nor the dealer could find the owner's manual, so they ordered a new one for me. I later found it in the secret pocket behind the seat which I didn't...
If you are leaving the hood open or have the alarm system turned on, the battery will have a higher amperage drain. So, keep the hood closed and the alarm system off while it is in your garage.
Jerry
I recently had a Viper tech adjust my sagging door, by simply lifting it with a little force, (without loosening any bolts,) to raise the back part of the door. He said that the reason it drops is because heavy people getting out of the car tend to push down on the top of the door to help...
I need a good mechanic or Viper tech in the Milwaukee area to install for a friend, the after-market IPSCO machined power steering pulley and bracket on a 97 GTS. Does anyone have a suggestion for such a person? Will need name and phone. Thanks
Jerry
Your Viper may have a aftermarket reduction pulley, which slows down the belt speed for track reasons. With the slower belt, your alternator is not running fast enough at idle to deliver the voltage needed for the ignition, and the engine stalls. Also your battery does not have enough voltage...
Your oil could be coming from the two vent hoses that come off the front of the valve covers, that dump into the airbox. This will happen with heavy breaking going into turns and send oil into the arifilter. The fix is to add a puke tank that collects the oil instead of letting it go to the...
If your car has a reduction pulley on the crank damper, you will get this problem when the battery is low in charge. The reduction pulley slows down the serpentine belt to take some load off the engine when reved to red line. The downside is that at long idle times, the battery is not charging...
I just did this a few days ago to fix the window guide. Take out the three screws, then use a paint scraper or flat blade screw driver to gently pry under the edge of the speaker. Be careful not to scratch the paint on the speaker grill. Pry in several places around the circumference and it...
I removed the plastic and made stainless sheet covers that are attached with clear RTV. They look a lot better and will still collapse when it needs to.
Jerry
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.