Recent content by RandyS
-
R
Need Help with plug wire order?
Thank you very much... Randy- RandyS
- Post #3
- Forum: RT/10 and GTS Discussions
-
R
Need Help with plug wire order?
Just replaced my plug wires and I think I have two of them in the wrong place. On the top of the coil packs, starting from the drivers side, I have 1,7,3,5,9. On the bpttom, 6,4,2,8, 10. The service manual does not give the order from side to side, just which cylinders are fired at the same...- RandyS
- Thread
- Replies: 5
- Forum: RT/10 and GTS Discussions
-
R
PICS: NJ red/black RT/10 wreck yesterday
About that wound?? Looks a bit like road rash. Seat belt?? Wow...- RandyS
- Post #16
- Forum: RT/10 and GTS Discussions
-
R
Calif. Smog check problem, need help
Thanks for the info guys. Just had a talk with the wizzard... Going with new plugs and wires then clear the PCM, do a sniff check and see what it reads, if that doesn't fix it, plan B. Might be a slow O2 sensor, have to dig up a scan tool for that one. Thanks again Where in Mission Hills...- RandyS
- Post #9
- Forum: RT/10 and GTS Discussions
-
R
Calif. Smog check problem, need help
I'll check on that Pep Boys stuff, and yes the People's Republic of California is a pain...- RandyS
- Post #5
- Forum: RT/10 and GTS Discussions
-
R
Calif. Smog check problem, need help
The test was done at a shop owned by a VCA member. Like yours, I have seen other modified cars pass.- RandyS
- Post #4
- Forum: RT/10 and GTS Discussions
-
R
Calif. Smog check problem, need help
Just had my 01 GTS in for smog and it failed. The only change to the car are Roe high flow cats. Talked to Roe and they have not had any complaints of this type. For the tech types the failure was the CO test at the higher RPM. This was the readings, 15mph 1640 rpm Max 0.48 Meas 0.15...- RandyS
- Thread
- Replies: 10
- Forum: RT/10 and GTS Discussions
-
R
My Gts Sapphire Blue Metallic Rocks
No, they stick on very well. A little soapy water to get them in the wright place, a small squeegee and a hair drier will do the trick. Check the marketplace for Bat's Overlays. They come cut to size, ready to go. Randy- RandyS
- Post #23
- Forum: RT/10 and GTS Discussions
-
R
My Gts Sapphire Blue Metallic Rocks
You might want to get rid of the orange things, turns and corners... Bats overlays for the rear turns, clear corners can be found on Ebay. Randy- RandyS
- Post #20
- Forum: RT/10 and GTS Discussions
-
R
DodgeVipersforsale.com
I purchased mine from Marv as well. It was in Ohio and took a couple of weeks to get here. The car was better than advertised. The two weeks was the killer... Randy- RandyS
- Post #22
- Forum: RT/10 and GTS Discussions
-
R
Tire question, again.
City, Thanks for the info... Mad, Still haven't made up my mind... Thanks Randy- RandyS
- Post #4
- Forum: RT/10 and GTS Discussions
-
R
Tire question, again.
Time for new ones, the orignals are a little tired. Is there a big difference between the PS and the PS2's? I wish an American company was in the mix, but I don't see any. Thanks Randy- RandyS
- Thread
- Replies: 4
- Forum: RT/10 and GTS Discussions
-
R
Boyd Coddington wheels
This might out there, but how would look with six holes?? Randy- RandyS
- Post #15
- Forum: RT/10 and GTS Discussions
-
R
Official Thread - SVS Short Throw Shifter Group Buy
Ron, I would like one with both bolts. Thanks, Randy- RandyS
- Post #118
- Forum: RT/10 and GTS Discussions
-
R
two post lift vs four post
I have a 2 post Bend Pac asymmetric (arms to the rear are longer). It is a little tricky with the viper, but no problems. Mine is a clear floor model, the hose and cables are over head, so you need about 11' of height. As far as the floor goes, I knew where the lift was going before...- RandyS
- Post #12
- Forum: RT/10 and GTS Discussions
