Recent content by rrapom
-
R
transmission issue
Hard time I have a question on my T56, having a problem going into reverse. Having hard time putting it in reserve with the engine idling, ok with engine off, lockout solenoid if working, put in new pilot shaft bearing and checked pressure plate and disc. Put on lift get the wheels spinning...- rrapom
- Thread
- Replies: 3
- Forum: SRT10 and SRT10 Coupe Discussions
-
R
tranny issues
I am having trouble shifting into reverse when car is idling . Goes into reverse with a little force and rpm. check lockout solenoid its ok, could it be the synchro for reverse? if it has one?- rrapom
- Thread
- Replies: 1
- Forum: SRT10 and SRT10 Coupe Discussions
-
R
Gen IV tranny issues
my transmission is having issues shifting into reverse when running, no issues when off. The lockout works fine, no problem shifting to the right just won't go into gear all the time. Put in a new greased shaft bearing. Still have them same problem, put the car up on jack stands and the wheels...- rrapom
- Thread
- Replies: 0
- Forum: SRT10 and SRT10 Coupe Discussions
-
R
NEW CLUTCH FORK BEARING INSTALL
GOOD EVENING , I AM INSTALLING A NEW 5037357AB CLUTCH FORK BEARING ON MY VIPER T56 SETUP. I HAVE A CLASSIC CAR WITH A HYD SETUP AND WHEN INSTALLING THE BEARING YOU LEAVE ABOUT .100 THOUSANDS CLEARANCE BETWEEN THE CLUTCH FORKS AND THE BEARING FACE. MY QUESTION IS WHEN INSTALLING THE VIPER...- rrapom
- Thread
- Replies: 1
- Forum: SRT10 and SRT10 Coupe Discussions
