Not sure if this motor is sold or not. It is in the classified area. Sounds like it would be a nice upgrade.
Gen 3 Chuck Tator Built Motor able to withstand 1000 rwhp - ViperClub Classifieds
I find the clutch pedal effort goes up as the clutch is on it's way out. I have had several gen 3 and 4 vehicles that had much less effort with a new clutch.
you will get a restriction code if you put the two black bags (for rain) over the filters and take the car to WOT. It does not alway put the light on, but you will always get a code.
Garrett
Both headlamps should have two shims on the outer stud closest to the side of the car. One should be white and one should be black. Below is a bulletin from Chrysler for viper headlamps.
Garrett
DISCUSSION:
Some customers may report that on occasion, vehicle exterior lamp assemblies are...
I just follow the owners manual (weird right lol). Basicly it says change oil and dont start.
The worst thing you can do is start the car and not reach full operating temperature. The oil will start to be contaminated due to condensation (water).
What is the difference in distance front to back in placement of the pick up? (Between the 2008 set up and the comp coupe set up) Do you have a measurement? Without a question the 2008 set up has better baffels.
Anything is better then the stock oil pan!! The 2008 system has better baffels and pick up placement then the comp coupe set up. That being said you can't beat the price of the comp coupe oil pan right now. Keep in mind they still have had failures with the Gen 4 vehicles. Depends how and where...
Tires are the last thing you want to save money on. I really don't understand why so many people will spend big money on upgraded brakes and bolt-on's for an engine but will drive around with tires that will not take a corner.
No reason to go nuts here lol.... keep in mind that you could if need be get a bumper super cheap from JonB. To post a 1/2 page ad would be a lot more money then fixing your car. Your next step is fill out the paper work for small claims court. Let them receive it and try to talk to them again...
There is and i don't think it says anything bad so i will post it before we all go and get our headlights replaced
DISCUSSION:
Some customers may report that on occasion, vehicle exterior lamp assemblies are fogged
with a light layer of condensation on the inside of the lenses. This may...
Talk to a general manager, If that does not work talk to the owner of the dealer. Be very clear on what you want. I would not be upset at 20km road test. Any major repairs I will take a ten drive on the highway and put about that much to make sure i have no leaks.
Good luck
The main purpose of the hood pad is to keep the radio interference under control. If you pull the pad down you will see metal foil on the top side of the pad. Also, the bottom corners of the pad have the ground wires for the pad. It may effect your radio reception without it.
Garrett
03-06 hoods are the same so it does not matter. The question everyone should be asking is how is the alignment with the front bumper? If it is okay look at the bolts that hold the fender to the upper fender support (bolts at top of fender)you should have a spacer/rubber washer between the fender...
I cant believe the amount of people who dont wear a seat belt when driving a viper. The air bags are only designed to deploy in a frontal collision within 30 degrees of the vehicle center line. (impact has to hit front of car to work correctly) Also, most people do not know the seat belts have a...
Generaly most knock sensors are tuned to the engine knock frequency that will range from 5 KHz to 10KHz, this depends on the engine design. I find it hard to believe the mounts could simulate this frequency. Also, the knock sensor value on a Chrysler vehicle is ignored at idle, This is when we...
The Corsa with high flows is really loud, for me it is to much and makes the vehicle uncomfortable to drive.
I have the full Belanger and love it. Headers look great. You should go to an event and listen to other members cars.
Garrett
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.