Never considered the hazards to paint from simple washing. Now i know. I have a two year old paint job with some very minor swirls in the clear coat. Do you recommend a product or process to remove something like like? Can most paint jobs be buffed or polished to your standards?
I used a 3/16 square long shaft screwdriver to remove vent plug. You have to cut off the end. Homey depot sells them 10 bucks or so.
Very quick heat up and then cool down sounds like problem I was chasing. Changed Tstat, added Roe fan kit and turned out to be a slowly dying water pump.
Thanks for the responses. Yes I tried all kinds of borrowed and or rented clamps also and none would fit without damage. Will try and order one from local dealer. Thanks again, 80 views and no answers, I was beginning to worry.
Hello all,
Need to replace ball joint seal boot, lower control arm, and it looks C-4150A tool along with 6983 is required. local Autozone did not have this.
Anyone know of a direct replacement or where to go for these?
My 02 had water pump problem. Now with it replaced I have NO heating problems. The impellar spins on the shaft which means no flow. Once cooled down it works fine until it gets hot or you step on it. Strange problem it was. Changed t stat, fan kit etc. all because this was on 01 problem. Now I...
The intermittent end of it truly sucked.
Finished the power steering pulley and bracket yesterday. Hope to have it all done this afternoon. Power steering pulley very stuborn to get off FYI.
Symptoms were temp increase after short hard acceleration. Once it got hot it would never cool down even 6th gear at highway speed. Next day it would be fine until you got on it again. I had thought this problem went away with the 01's. Chuck set me straight. Shaft starts spinning under hard...
Have an 02 GTS ACR which I thought was past the problems of bad plastic impellars but Chuck set me straight. Interesting how they die slowly, spin on shaft for awhile, catch for a while, all the time slowly getting worse.
Had tunnel vision this was an 01 or earlier problem so never considered...
Tend to agree with the air in the system. Drove it Sunday night not very spirited and got right up to red at highway speed as I said earlier. So Monday I call Sean at Roe where I bought the stuff, told me I was out to lunch thinking high flows could have anything to do with it, told him I...
I have an 02 GTS ACR 6k miles no major mods, recently installed High flow cats and noticed temp while driving fluctuating more than before. To me it seemed the stat was not working right since it moved so quickly hot to cold when RPMs are low and fan is on.
Reading posts it made sense to me to...
I have not noticed any signal loss, but also do not use until in driveway. cracks me up all the different uses of that little hole.
The sill vents I did myself. You do not notice them unless you know to look for them.
Anyone interested I will snap some photos and send. I drilled 3 pairs of...
Stuck my garage door opener in the ashtray. Great place for it, easy to use and out of site. Linear is the maker of the remote and the ashtray is MTW I think. Took some mods to rubber in the ashtray, remote had to have the keyring loops shaved off, 30 minutes with a hacksaw. hopefully photos are...
Have an 02 GTS and would like to powerdercoat the square aluminum cross member in front of the engine. I see some TT upgrades remove this and replace it with a custom version. Anyone still have this piece and want to sell it?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.