Last two times I've driven the car ('03 w/25k miles) I've noticed a considerable hesitation when releasing the clutch from a dead-stop, at speed it drive's okay but still seems like it's slower than normal. Engine sounds like it's might be missing on the driver's side, also noticing an...
Just got my \'03 back from the shop
I had a header-bolt break, one end still in the head. Eddie Martin :2tu: down in Phoenix (@ Bill Luke Dodge) did a hell of a job putting her back to normal. Also had the pcm removed and tuned by DC Perf. I haven't had her dyno'd since the stock run...
In a fit of cleaning I deemed it necessary to remove my MGW shifter bezel to clean the leather boot and failed to remember that the MGW bolts come pre-loctited... long story short is that I broke a couple of the tabs that the bezel mounts to, they snapped right off the console. What's barely...
Silver '03, Belanger Tri-Y's, full catback exhaust, crossover delete. All MGW interior appointments. K&N filtercharger and a painted hoodliner.
Just ordered her some tires for her birthday and will be turning the rotors and throwing on some EBC's at the same time.
She's been to the...
Sitting at a stoplight in the left lane (2 cars ahead of me), lady stopped (yes-she was fully stopped) behind me decides to floor her grand cherokee because the cars in the right lane started to roll when the light changed green. Her excuse to the cop was that I sit soooo low... [******]...
Hey guys, two days ago I noticed that neither the center sub nor the speaker above it were operating. Using the fade and balance I have verified correct operation of the rear tweeters (under the roll hoops) and the front speakers.
At first I assumed that all of the speakers (except the sub)...
Gents,
I pulled a p0138 and p0158 which are "02 sensor high voltage banks 1 sensor 2 & bank 2 sensor 2" (respectively). So both of my sensor two's are reading high voltage. This has only occurred since having my Belanger headers installed. I recently took my car to the dealership and...
I had my Belangers installed about a month ago and have now gone through a second o2 sensor (passenger side). First one failed at 700 miles after install, no rich or lean codes, just failed to work at all. The dealer replaced the sensor under warranty the first time but I don't want to take it...
Alright y'all, I got the Belanger complete exhaust package installed and all I can say is WOW! :cool: It's hard to believe how much the headers really wake up the exhaust note, not to mention your neighbors...
I took the car to Phoenix and had the install done at Fat Albert's Motorsports...
Dyno\'d the Viper today (first time)
She hit 449.4hp and 489.0tq corrected. I do have the K&N intake installed. That - and a big-azz grin. :D
the shop that did it specializes mainly in imports. they were all kinda shocked to see it hit ~155-160mph at rev-limit in 4th!
I need some recommendations y'all. I plan on driving to wherever the shop may be (I don't trust anyone local) and I live in the Albuquerque, NM area (suburbs). I'm roughly a days drive from the following locals: Phoenix (6-7hours), Dallas(10-11hours), Denver(5-6 hours), LA (10-12hours). BTW...
So I'm going to the VOI but the wife can't make it due to scheduling conflicts. If I were to take my brother or brother-in-law as a guest (having paid their registration fee of course), would they be able to participate in any of the events (SRT Rams, SRT-4 driving, etc...) or are they just...
My dealership sent me a letter saying that they've paid for my first year of the VCA but I heard it could take up to two months to receive anything from the VCA. The VOI registration asks for your 5-digit member number. Would I be missing out on any club activities if I registered as "not a...
I got a letter today from the dealership (Zangara Dodge) that I bought my SRT-10 from, stating that they've paid for my membership to the VCA and a subscription to Viper magazine. Wasn't expecting any of that :2tu:
has anyone dyno\'d before and after srt aircharger install?
thinking about the k&n system but wanted to check cost-effectiveness vs. dyno results. thanks.
'03 Silver SRT-10 (new). Picked it up at a local dealership for $75.6 out the door. Probably could've gotten it cheaper elsewhere but I'm still happy with the deal.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.