Chin Guard

[Pythonpete]

Does anyone use the chin guard to protect your vipers chin from scrapes? If so which one? Has anyone had any negative experiences?

 

[rcl4668]

Sorry, I am not familiar with the chin guard you mentioned but I had a clearbra material (VentureShield) applied to the front lip spoiler and the flat area below it. While this may protect from minor srcapes I doubt it would prevent a hard impact with curbs, etc.

/Rich

 

[DavidSB]

I recently saw this one from PartsRack on an SRT-10. Slightly different in that the one I saw mounted on the two outside/forward bottom pan bolts, not with three.

http://partsrack.blastmart.com/customer/product.php?productid=1384&cat=168&page=1

 

[Pythonpete]

I've seen that too, does anyone have any experience with any of them?

Thanks

 

[Paul S Lacey]

Had one one my GENII well made good piece of kit only down side was taking it off to straighten when you parked to close to a curb...LOL

Don't they do one for the SRT ?? But I am sure the Roe one could be maded to fit.

 

[Pythonpete]

Yes, they do make one for the Gen III. I was worried about potential damage done to my car's chin from the guard itself. Is it padded on the other end?

 

[Robsviper]

I just got one for my Gen 111 -- they have sticky rubber pads to protect the body. Goes on in minutes.

Got mine from Snake Oyl Products.

 

[Pythonpete]

thanks guys.