Goggles Pizano's latest activity
-
GVery carefully...........................
-
GGoggles Pizano replied to the thread Cold Start & Idle Video – Viper Gen 3 – Does This Sound Healthy?.There are a substantial number of vipers daily'd and high mileages.
-
GGoggles Pizano replied to the thread window regulator repair.@vjjack04 i meant how much was the cost to fix it by the AZ company? Because there is also a FL company doing the same. Both have...
-
GGoggles Pizano replied to the thread window regulator repair.@vjjack04 how much from the AZ? There are the AZ guys and there are FL guys.
-
GGoggles Pizano replied to the thread High Temp Paint for Side Sills.High heat paint needs high heat cycles(baking) to cure correctly. It is not just spray it. Even brake caliper paint you need to...
-
GGoggles Pizano replied to the thread Passenger cylinders not firing correctly, right cat glowing after 2 mins.If cat is not hot, then it is not working. Fuel trims should have been looked at first. Start first with checking all the cables and...
-
GGoggles Pizano reacted to Dan Cragin's post in the thread Suspension gurus: Ride height specification for coilover install? with
Like.
I always run 3/4 to 1 inch Rake (Rear Higher) Full Tank / Driver weight in the left seat Ride height measured from the centerline of... -
GI have several good used ones for sale. PM me
-
GGoggles Pizano reacted to 99RT10GTS's post in the thread Gen 4, 09, Transmission removal problems with Like.
DO NOT TRY TO REMOVE THE TRANSMISSION ALL IN ONE UNIT!!!! You have to get the 8 bolts removing the trans FROM the bellhousing FIRST!!!
-
GGoggles Pizano reacted to Steve M's post in the thread Gen 4, 09, Transmission removal problems with Like.
Now that I re-read the original post, this. Unbolt the transmission from the bellhousing...the bellhousing stays attached while you...
-
GIt works just fine. You don't even have to swap the impeller.
-
GGoggles Pizano reacted to Viper Specialty's post in the thread Another crank no start thread but with a twist with Like.
Jim and I figured out what was going on with this car early last month. Had a power supply issue from the ignition switch, and a...
-
GGoggles Pizano reacted to GTS Dean's post in the thread Another crank no start thread but with a twist with Like.
^^^^Listen to this man!!!^^^
-
GGoggles Pizano reacted to Dan Cragin's post in the thread Another crank no start thread but with a twist with Like.
I installed a Viper motor in a 240 and 280z back in the day. A bit of sorting. Reach out if you need advice. The front suspension and...
-
GGoggles Pizano replied to the thread Need a Dodge contact for official document.You are understanding his post, I was just saying that he should call some dealers there and see if they do parts lookup like they do...
Latest posts
-
-
-
-
-
-
-
-
-
More parts found... (1) MGW First Strike Knob & B&M Shifter
- Latest: Goggles Pizano
-