Recent content by Kevin M Melisz
-
Looking For Stock Exhaust
I have stock headers and cats from my 2008.- Kevin M Melisz
- Post #3
- Forum: SRT10 and SRT10 Coupe Discussions
-
ARH, Belanger, Emissions in GA
I have a full Belanger system with a single cat, utilizing the stock O2 sensors on my Gen IV and I have no issues in New York. I got to believe that it would pass GA. That said, you can always give them a call at Belanger they are glad to help and provide support.- Kevin M Melisz
- Post #2
- Forum: Generation V Discussions / SRT Coupe, GTS, GTC, AC
-
Quietest 3" exhaust?
MoparMap, have you spoken yo Lou Belanger directly? He is surprisingly easy to get ahold of and loves talking exhaust for Vipers. I would recommend giving him a call and getting his advice. Kevin- Kevin M Melisz
- Post #5
- Forum: SRT10 and SRT10 Coupe Discussions
-
Belanger vs corsa
I went with full Belanger on my SRT-10. I know different generation but fit and instructions were very good. Also Lou himself will take a call if you have questions, whi lch is very helpful. Kevin- Kevin M Melisz
- Post #8
- Forum: RT/10 and GTS Discussions
-
Full fluid flush and change - list of what I need? (2008 SRT-10 Coupe)
Bradg33 Last year I did the fluids in my 2008. Here is my list. 11 qt of 0W-40 mobil Dodge 05038041AA Filter Lucas Synthetic 75W-90 1.5 Qt 4oz Ford friction modifier ATF +4 automatic transmission fluid 3.5 quarts I didn't do brake fluid. Kevin- Kevin M Melisz
- Post #3
- Forum: SRT10 and SRT10 Coupe Discussions
-
2008 SRT 10 Differential clutches defective
I will second, exactly what John said. I wanted the 3.55 gears and I worked with Jerry, he is Super nice and knowledgeable. I pulled my own rear-end (wasn't that bad of a project) and shipped it to California. I just did this in the spring, so if you have any questions feel free to contact me...- Kevin M Melisz
- Post #4
- Forum: General Viper Discussion
-
Exhaust on a 2003 SRT10
I have a gen 4 and went through this process of deciding what exhaust to get last year. I searched the internet and you tube videos to help me decide. I end up with a full Belanger system, header all the way back and couldn't be happy. If you want to discuss further, don't be afraid to call or...- Kevin M Melisz
- Post #6
- Forum: SRT10 and SRT10 Coupe Discussions
-
Aftermarket exhaust question
I went with the 2.5" not 3", after speaking with Lou Belanger, 2.5" actually gives you better performance and a better sound. Yes 3" is louder but at cruising speeds it will be a loud drone and can be obnoxious. With the 2.5" it gives a louder sounds especially at higher RPMS but at cruising...- Kevin M Melisz
- Post #16
- Forum: SRT10 and SRT10 Coupe Discussions
-
Gen 4 New York State Inspection - Incomplete Readiness Tests
All, I just wanted to send the update/conclusion. My battery was 6-7 years old and I ended up replacing it just to make sure this wasn't causing the issue. After that I tried all the steps/procedures posted on line to get the O2 and Cat test completed. I had a scanner and would check each time...- Kevin M Melisz
- Post #12
- Forum: SRT10 and SRT10 Coupe Discussions
-
Aftermarket exhaust question
John D, I did a full Belanger system on my 08 in the fall. Everything else on my car is stock, and I kept the stock tune. I have 1000 miles on it since the installation and don't have a CEL. If you have any other questions about the installation, feel free to reach out to me directly...- Kevin M Melisz
- Post #14
- Forum: SRT10 and SRT10 Coupe Discussions
-
In your opinion, which is a better deal...
Anthony, Last year I purchased a 2008 and I believe the Gen4 offers a lot more car than the Gen3 for a little more money. Like everyone else has stated it really depends on what you are looking for and the quality of the car not mileage. If you want to have a discussion about my similar...- Kevin M Melisz
- Post #9
- Forum: General Viper Discussion
-
Gen 4 New York State Inspection - Incomplete Readiness Tests
BYAIC, My battery is about 6 years old but sits on a tender during winter months and has never seemed weak or problems starting the car cold. I guess I could take it to a Autozone to have them run a check on the battery to make sure. redtanrt10, I appreciate the advice I will try to the...- Kevin M Melisz
- Post #6
- Forum: SRT10 and SRT10 Coupe Discussions
-
Gen 4 New York State Inspection - Incomplete Readiness Tests
Looking for any help or advice from the community. I have a recently installed a complete (Full) Belanger exhaust on my 2008. After installation I have driven the car about 300 miles with no CEL. I went to take my car for its annual NYS inspection and failed for 2 incomplete readiness tests on...- Kevin M Melisz
- Thread
- Replies: 11
- Forum: SRT10 and SRT10 Coupe Discussions
-
Fluids and How many Quarts?
Ironically, I am in the middle of flushing my clutch fluid in my 2008. The car has only 12k on it and I didn't have any issue prior to flushing, just saw it was black and did it just for maintenance reasons. I was able to easily remove and refill the system by gravity bleeding. Everything seemed...- Kevin M Melisz
- Post #14
- Forum: RT/10 and GTS Discussions
-
Gen 4 Rear Differential Removal
I am looking for some advice removing my rear differential on 2008 Vert. I am planning on sending to Unitrax to have 3.55 gears installed. I have read all old posts and seen some conflicting answers. Currently the car is in the air, drive shaft removed, 4 main support bolts loose and half...- Kevin M Melisz
- Thread
- Replies: 3
- Forum: SRT10 and SRT10 Coupe Discussions
